Motorola Communications Gateway manual Cabling and Startup for a Single User

Introduction Before You Begin

Installation & Configuration

Troubleshooting FAQ Glossary License

Cabling and Startup for a Single User, continued

3

2
1	1

Battery hook

2

6On the battery compartment cover, push in on the tabs, as shown by arrows 1 in the illustration at top left.

7Carefully remove the battery compartment cover by lifting up about 2 to 3 cm (1 inch) and then pulling straight out. To avoid damaging the cover, be sure you rotate it only slightly (arrow 2) before pulling it out (arrow 3).

For a description of the battery compartment, see “Battery Compartment” on page 6.

8As shown at lower left, depress both battery snaps (arrows 1) while gently raising the positive end of the battery (arrow 2).

9When the battery rotates past the snaps, slide the battery out as shown below. Be sure you do not damage the battery wires or terminals.

1

1

Battery snaps

Home	Print	X	14	Communications Gateway User Guide
		Exit