ADTRAN 600 Series user manual Security, Dotted decimal format

Page 34

Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B

Page 34

Security

Filter Defines

The Total Access 600 can filter packets based on certain parameters within the packet. The method used by the Total Access 600 allows the highest flexibility for defining filters and assigning them to a PVC. The filters are set up in two steps: (1) defining the packet types, and (2) adding them to a list under the PVC. This menu is used to define the individual filter defines based on packet type.

Filter Defines /MAC Filter Defines

The MAC filter is applied to bridge packets only. Bridge packets which are forwarded by the bridge functionality of the Total Access 600 are defined here. Up to 32 MAC defines can be specified.

NAME	Identifies the filter entry.
SRC ADDR	48-bit MAC source address used for
	comparison. (hexadecimal format)
SRC MASK	Bits in the MAC source address which are
	compared. (hexadecimal format)

DEST ADDR

DEST MASK

48-bit MAC destination address used for comparison. (hexadecimal format)

Bits in the MAC destination address used for comparison. (hexadecimal format)

MAC TYPE	16-bit MAC type field used for comparison.
	(hexadecimal format)
TYPE MSK	Bits in the MAC type field used for comparison.
	(hexadecimal format)

Filter Defines /Pattern Filter Defines

The pattern filter is applied to bridge packets only. That is any packet which is forwarded by the bridge functionality of the Total Access 600. Up to 32 pattern defines can be specified.

NAME

OFFSET

PATTERN

MASK

Identifies the filter entry.

Offset from beginning of packet of where to start the pattern comparison.

64 bits used for comparison. (hexadecimal format)

Bits in the pattern to be compared. (hexadecimal format)

Filter Defines /IP Filter Defines

The IP filter defines apply to any IP packet, whether it is routed or bridged. Up to 32 IP defines can be specified.

NAME	Identifies the filter entry.
IP SRC	IP address compared to the source address.
	(dotted decimal format)

Total Access 600 Series User Manual

© 2002, ADTRAN, Inc.

Image 34

Contents Total Access 600 Series Shdsl IAD Trademarks To the Holder of the ManualSafety Instructions 2002, ADTRAN, Inc 2002, ADTRAN, Inc 2002, ADTRAN, Inc Warranty and Customer Service Limited Product WarrantyRepair and Return Customer Service, Product Support Information, and TrainingPre-Sales Inquiries and Applications Support Post-Sale Support Installation and Maintenance SupportTraining Total Access 600 Series Shdsl IAD User Interface Guide +@A1 +@&.&$$ +@,%.% @/& % @/& %.&$$ @.&$$ @/1 @.%+0% %B,% ##%B 8= $*+*$&,$&-# # #$% Figures Firmware Updates Analog LifelineVoice Over DSL Overview Voice over DSL System Info Serial Number Bootcode RevisionPart Number Firmware RevisionTelnet Access System ConfigNetwork Timing Mode Telnet User ListMaint Port Menu Password ProtectInstructions for Changing Passwords Step Action LevelNetwork Time Upgrade Firmware System UtilityConfig Transfer Ping Dslam Type Configuring WAN SettingsATM Config Layer One InterfaceATM Stats Data ScramblingAP Rx OAM Cells AP Receive Cell ErrorsAP Rx Cells AP Receive Cells DiscardedAAL5 No ATM Frames AAL5 Receive ErrorsAAL5 Receive Discarded Frames AAL5 No Data PacketsConfiguring the Router Configuration GlobalText string used to represent the domain name Bridge Security Dotted decimal format2002, ADTRAN, Inc Ethernet Ethernet MenuUse this menu to enable RIP on the LAN interface MAC AddressWAN This selection enables IP on this PVC RFC 1483 Bridge PPPoATMThis is the username used to authenticate the PPP peer Only routes not learned on the WAN connection This is the PPP encapsulation. LLC or VC-Mux Configuring the Router Status Router/Status MenuConfiguring the Router Logs Connection Log Sys log HostPPP Log Network LogConfiguring Voice Support Config Call ControlPVC Stats Configuring Voice Support StatusGateway Stats Pots StatsMenu Managing the Modules ModulesTest FXS Configuration Managing the Modules V.35 SetupMode Following settings are used for FRF5 Following settings are used for FRF8 Appendix A. Updating Total Access 600 Firmware using Xmodem Updating Firmware via a Forced DownloadPress $until a menu appears Updating Firmware via the Console Menus When prompted, press to erase flashSelect -# # for #9 Appendix B. Updating Total Access 600 Firmware using Tftp Message Meaning Message Meaning Menu Path Left Pane Status Bar ModeSystem Time Window Pane Navigation Right Window Pane NotationAdditional Terminal Menu Window Features Navigating Using the Keyboard KeysSession Management Keystrokes Getting Help Application Diagram Voice Turn Up Step Action Appendix E. RFC1483 Quick Start IP Routing IP Routing Step Action Appendix F. RFC1483 Quick Start IP Routing with NAT OptionsAppendix G. RFC1483 Quick Start Bridging Bridging Step ActionAppendix H. Craft Port Connection Pin-out 2002, ADTRAN, Inc