Total Access 600 Series SHDSL IAD User Interface
Voice Turn Up
Step | Action |
|
|
| From the Total Access 600 main menu, select the WAN menu. Select |
1 | DSLAM TYPE and select the name of the DSLAM type you are using. |
(At this point you need to back out of the menu to save the changes. | |
| The unit will need to reboot if it was not previously configured for this |
| DSLAM type.) |
|
|
2 | Select DSL RATE CONFIG (BIT RATE) and change the setting to match |
that in your DSLAM. (If this field is | |
| autobaud to expire and the field will change to writeable.) |
|
|
3 | Select WAN, and then select the ATM CONFIG menu. |
|
|
4 | Enter the IDLE CELLS format for your network. |
|
|
5 | Set DATA SCRAMBLING appropriately for your network. |
|
|
| Back all the way out to the top level Total Access 600 menu, and then |
6 | select the VOICE menu. (From this menu, the appropriate Voice |
| information for working with the Voice Gateway is entered.) |
|
|
| Select CONFIG, and from the CONFIG menu, enter the Gateway type |
| under CALL CONTROL and enter the VPI and VCI values for |
7 | communicating with that Gateway. |
| CALL CONTROL should be set to the Gateway type, and the VPI and VCI |
| values should be set appropriately for your network. |
|
|
| To verify correct setup, use the STATUS menu (under the VOICE menu) |
| to look at the current status of the voice connection. |
| Under STATUS, you can view the GATEWAY STATS and information |
| about the voice PVC along with information about the POTs ports |
8 | available on the Gateway. |
| The GATEWAY STATS menu should show the Gateway Link is up (if |
| everything is configured correctly). |
| A visual inspection of the VOICE LED on the front panel will also yield |
| the status. Green = Up. Red = Down. |
|
|
Total Access 600 Series User Manual | © 2002, ADTRAN, Inc. |