ADTRAN 600 Series user manual Only routes not learned on the WAN connection

Page 42

Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B

Page 42

• Route/Force IP

When set to YES, the Total Access 600 will force the PPP peer to use the IP address in the LOCAL IP for this profile as its WAN IP address. Normally this is set in the NO (def) position.

RIP

The RIP parameters can be adjusted from their defaults under this menu.

• Mode

The Total Access 600 performs RIP over the WAN connection when this is set to ON (def).

• Protocol

The Total Access 600 performs version 1, V1 (def), or version 2, V2, of RIP on this WAN connection.

• Method
SPLIT HORIZON	Only routes not learned on the WAN connection
	are advertised.
POISON REVERSE	All routes are advertised, including routes learned
5*%6	from the WAN connection. These routes are poi-
	soned.

NONE

• Direction

TX AND RX5*%6

All routes are advertised, including routes learned from the WAN connection. No attempt is made to poison these routes.

RIP advertisements are transmitted and listened to on the WAN connection.

TX ONLY	RIP advertisements are transmitted and not listened
	to.
RX ONLY	RIP advertisements are listened to but not trans-
	mitted.

• Triggered

When set to YES, only IP RIP updates are sent when the routing table has changed and learned routes are not "aged." When set to NO (def), updates are sent periodically.

• Retain

When this Connection List entry is disconnected and this parameter is set to YES, all routes learned from this WAN connection are retained and their routing interface is set to idle.

PPP

The Total Access 600 supports the IETF standards for the Point-to-Point Protocol. The PPP state machine running in the Total Access 600 can be fine-tuned to support many applications that can be employed. The configurable items under this menu can be changed from their default values for special cases.

VJ Compression

When this item is set to ON, the Total Access 600 will perform TCP/IP header compression known as Van Jacobson compression to the PPP peer.

Total Access 600 Series User Manual

© 2002, ADTRAN, Inc.

Image 42

Contents Total Access 600 Series Shdsl IAD Trademarks To the Holder of the ManualSafety Instructions 2002, ADTRAN, Inc 2002, ADTRAN, Inc 2002, ADTRAN, Inc Warranty and Customer Service Limited Product WarrantyCustomer Service, Product Support Information, and Training Repair and ReturnPre-Sales Inquiries and Applications Support Installation and Maintenance Support Post-Sale SupportTraining Total Access 600 Series Shdsl IAD User Interface Guide +@A1 +@&.&$$ +@,%.% @/& % @/& %.&$$ @.&$$ @/1 @.%+0% %B,% ##%B 8= $*+*$&,$&-# # #$% Figures Firmware Updates Analog LifelineVoice Over DSL Overview Voice over DSL System Info Serial Number Bootcode RevisionPart Number Firmware RevisionTelnet Access System ConfigNetwork Timing Mode Telnet User ListMaint Port Menu Password ProtectInstructions for Changing Passwords Step Action LevelNetwork Time Upgrade Firmware System UtilityConfig Transfer Ping Dslam Type Configuring WAN SettingsATM Config Layer One InterfaceATM Stats Data ScramblingAP Rx OAM Cells AP Receive Cell ErrorsAP Rx Cells AP Receive Cells DiscardedAAL5 No ATM Frames AAL5 Receive ErrorsAAL5 Receive Discarded Frames AAL5 No Data PacketsConfiguring the Router Configuration GlobalText string used to represent the domain name Bridge Security Dotted decimal format2002, ADTRAN, Inc Ethernet Ethernet MenuUse this menu to enable RIP on the LAN interface MAC AddressWAN This selection enables IP on this PVC RFC 1483 Bridge PPPoATMThis is the username used to authenticate the PPP peer Only routes not learned on the WAN connection This is the PPP encapsulation. LLC or VC-Mux Configuring the Router Status Router/Status MenuConfiguring the Router Logs Connection Log Sys log HostPPP Log Network LogConfiguring Voice Support Config Call ControlPVC Stats Configuring Voice Support StatusGateway Stats Pots StatsManaging the Modules Modules MenuTest FXS Managing the Modules V.35 Setup ConfigurationMode Following settings are used for FRF5 Following settings are used for FRF8 Appendix A. Updating Total Access 600 Firmware using Xmodem Updating Firmware via a Forced DownloadPress $until a menu appears When prompted, press to erase flash Updating Firmware via the Console MenusSelect -# # for #9 Appendix B. Updating Total Access 600 Firmware using Tftp Message Meaning Message Meaning Status Bar Mode Menu Path Left PaneSystem Time Window Pane Navigation Right Window Pane NotationAdditional Terminal Menu Window Features Navigating Using the Keyboard KeysSession Management Keystrokes Getting Help Application Diagram Voice Turn Up Step Action Appendix E. RFC1483 Quick Start IP Routing IP Routing Step Action Appendix F. RFC1483 Quick Start IP Routing with NAT OptionsAppendix G. RFC1483 Quick Start Bridging Bridging Step ActionAppendix H. Craft Port Connection Pin-out 2002, ADTRAN, Inc