Total Access 600 Series SHDSL IAD User Interface
Page 58
Perform Steps Below in the Order Listed
1.Using a Telnet program,&$ to Total Access 600.
2.Select ;#!;1 #<.
3.Select 1 for #9 .
4.Enter into TFTP SERVER IP ADDRESS, the IP address of the network server that was recorded earlier.
5.Enter into TFTP SERVER FILENAME, the full path name and filename of the update file that was recorded earlier.
6.Select @AB to start the update process. Enter ; to confirm the transfer and to set up the module to receive the TFTP upload.
During the TFTP upload process, various status messages display in 1
to indicate progress. The table below describes these messages.
When the update has successfully completed, #1! displays in . The Total Access 600 restarts immediately and resumes operation.
If an error occurs during the update, an error message will display in the field. If this occurs, return to Step 3 and attempt the update again. If the same error occurs, contact ADTRAN Technical Support.
During the TFTP upload, various status messages display to indicate progress. The following table describes these messages.
Message | Meaning |
|
|
|
|
Contacting Server | Indicates communication with the TFTP network server |
| is trying to be established with the specified server |
| address in the TFTP Server IP Address field. |
|
|
Beginning TFTP | Indicates communication with the TFTP network server |
Transfer | has been established and the update file is being trans- |
| ferred between Total Access 600 and the TFTP network |
| server. |
|
|
Completed | Indicates the Total Access 600 product successfully |
| received the update file. |
|
|
Total Access 600 Series User Manual | © 2002, ADTRAN, Inc. |