ADTRAN 600 Series user manual Text string used to represent the domain name

Page 32

Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B Page 32

Static Routes

Use this menu to enter static routes to other networks.

ACTIVE

IP ADDRESS

SUBNET MASK

GATEWAY

HOPS

PRIVATE

DHCP Server

DHCP MODE

Adds this static route entry to the IP routing table when set to ; and removes it (if it was previously added) if set to (def).

The IP address of the host or network address of the device being routed to.

Determines the bits in the previous IP address that are used. If this is to be a host route, it must be set to all ones (255.255.255.255).

The IP address of the router to receive the forwarded IP packet.

The number of router hops required to get to the net- work or host. Maximum distance is 15 hops.

When set to , the Total Access 600 will advertise this static route using RIP. Setting to ; means that the route is kept private.

When set to , the Total Access 600 acts as a DHCP server and will dynamically assign IP, net- work mask, default gateway, and DNS addresses to any device which transmits a broadcast DHCP re- quest. The addresses assigned are based on the Total Access 600’s own IP address and will be within the same network.

DHCP RENEWAL TIME

Domain Names

The number of hours that the DHCP server should allow the device before it is required to send a new DHCP request. The default is 15 hours, and 0 repre- sents an infinite lease.

Enter the Total Access 600's domain name and the primary and secondary DNS servers in this menu.

DOMAIN NAME	Text string used to represent the domain name
	used by the Total Access 600.
PRIMARY DNS	First server to which domain name requests are
	sent.
SECONDARY DNS	Server used as a backup, in case the primary ad-
	dress does not respond to the request.
PRIMARY NBNS/WINS	Server to which NT domain name requests are
	sent.
SECONDARY NBNS/WINS	Server used when there is no response from the
	primary server.

Total Access 600 Series User Manual

© 2002, ADTRAN, Inc.

Image 32

Contents Total Access 600 Series Shdsl IAD Trademarks To the Holder of the ManualSafety Instructions 2002, ADTRAN, Inc 2002, ADTRAN, Inc 2002, ADTRAN, Inc Warranty and Customer Service Limited Product WarrantyPre-Sales Inquiries and Applications Support Customer Service, Product Support Information, and TrainingRepair and Return Training Installation and Maintenance SupportPost-Sale Support Total Access 600 Series Shdsl IAD User Interface Guide +@A1 +@&.&$$ +@,%.% @/& % @/& %.&$$ @.&$$ @/1 @.%+0% %B,% ##%B 8= $*+*$&,$&-# # #$% Figures Firmware Updates Analog LifelineVoice Over DSL Overview Voice over DSL System Info Bootcode Revision Part NumberSerial Number Firmware RevisionSystem Config Network Timing ModeTelnet Access Telnet User ListPassword Protect Instructions for Changing Passwords Step ActionMaint Port Menu LevelNetwork Time Upgrade Firmware System UtilityConfig Transfer Ping Configuring WAN Settings ATM ConfigDslam Type Layer One InterfaceATM Stats Data ScramblingAP Receive Cell Errors AP Rx CellsAP Rx OAM Cells AP Receive Cells DiscardedAAL5 Receive Errors AAL5 Receive Discarded FramesAAL5 No ATM Frames AAL5 No Data PacketsConfiguring the Router Configuration GlobalText string used to represent the domain name Bridge Security Dotted decimal format2002, ADTRAN, Inc Ethernet Ethernet MenuUse this menu to enable RIP on the LAN interface MAC AddressWAN This selection enables IP on this PVC RFC 1483 Bridge PPPoATMThis is the username used to authenticate the PPP peer Only routes not learned on the WAN connection This is the PPP encapsulation. LLC or VC-Mux Configuring the Router Status Router/Status MenuConfiguring the Router Logs Sys log Host PPP LogConnection Log Network LogConfiguring Voice Support Config Call ControlConfiguring Voice Support Status Gateway StatsPVC Stats Pots StatsTest Managing the Modules ModulesMenu FXS Mode Managing the Modules V.35 SetupConfiguration Following settings are used for FRF5 Following settings are used for FRF8 Appendix A. Updating Total Access 600 Firmware using Xmodem Updating Firmware via a Forced DownloadPress $until a menu appears Select -# # for #9 When prompted, press to erase flashUpdating Firmware via the Console Menus Appendix B. Updating Total Access 600 Firmware using Tftp Message Meaning Message Meaning System Time Status Bar ModeMenu Path Left Pane Window Pane Navigation Right Window Pane NotationAdditional Terminal Menu Window Features Navigating Using the Keyboard KeysSession Management Keystrokes Getting Help Application Diagram Voice Turn Up Step Action Appendix E. RFC1483 Quick Start IP Routing IP Routing Step Action Appendix F. RFC1483 Quick Start IP Routing with NAT OptionsAppendix G. RFC1483 Quick Start Bridging Bridging Step ActionAppendix H. Craft Port Connection Pin-out 2002, ADTRAN, Inc