Total Access 600 Series SHDSL IAD User Interface
Page 56
9.Change the emulation software properties to 9600 baud. Disconnect and connect to the unit at this transmit rate and continue configuring the unit as normal.
It is suggested that a factory default be conducted after the unit is updated with new firmware.
Updating Firmware via the Console Menus
1.Using a VT 100 terminal emulation communication software package which contains XMO- DEM protocol support, log in to TA 600.
2.Select ;#!;/1 #<.
3.Select -# # for #9 .
4.Press $on @AB
5.When prompted, press ; to erase flash.
When Total Access 600 is ready to receive the XMODEM upload, the menu screen will clear and display $,(*$*%$. If this does not appear, please review the steps above for possible configuration errors.
6.From the terminal emulation software, begin the XMODEM upload by using the appropriate command sequence. (If necessary, refer to terminal emulation software documentation for help. Also, when specifying the filename, ensure that the file transferred is the one pro- vided by ADTRAN. Otherwise, the update will not complete successfully.)
Because XMODEM data is being transferred
7.When the update has successfully completed, #1! displays in
. The module restarts immediately and resumes operation. If an error occurs during the update, an error message will display in the field. If this occurs, return to Step 3 and attempt the update again. If the same error occurs, contact ADTRAN Techni- cal Support.
Total Access 600 Series User Manual | © 2002, ADTRAN, Inc. |