1394 Interface Unit Type 4510
1394 Interface Unit Type 4510
Note
❒Depending on the model you use, the 1394 Interface Unit, the Net- work Interface Board, and the 802.11b Interface Unit cannot be installed in the printer at the same time. For more information, see p.11 “Installing Options”.
Important
❒Printing using "SCSI print "(Win- dows 2000) device and "IEEE 1394 and SCSI printers" (Windows XP) with the optional 1394 Interface Unit is possible under Windows 2000 and Windows XP. Printing with IP over 1394 is possible under Windows XP.
❒With Windows 2000, the 1394 In- terface Unit can only be used with Service Pack 1 or later. If the Serv- ice Pack is not installed, the con- nectable SCSI print device in a 1394 bus is only one, and the client cannot install the printer driver without using an account with Ad- ministrators permission.
❒Before touching the 1394 Interface Unit, touch something metal to discharge any static electricity. Static electricity can damage the 1394 Interface Unit.
❒Unplug all the interface cables from the printer before installa- tion. If you take out the controller board with cables plugged in, the 1394 Interface Unit might be dam- aged.
❒Use the 1394 interface cable that comes with this printer.
❒Do not plug or unplug the 1394 in- terface cable while installing the printer driver.
Installing the 1394 Interface
Unit
A Check the contents of the box for |
|
2 | |
the following items: |
|
•1394 Interface Unit
•1394 Interface Cable (6 pins x 4 pins)
•1394 Interface Cable (6 pins x 6 pins)
•Installation Guide
B Confirm that the followings are true:
•The power switch is turned off.
•The interface cable is un- plugged from the printer.
Note
❒If the Duplex Unit is not at- tached, go to step D.
C If the Duplex Unit is attached, push down the lever on right side (A) and pull out the Duplex Unit until it stops (B).
ZGDX320J |
25