Ethernet Configuration
G If you use TCP/IP, assign the IP address to the printer.
Note
❒To get the IP address for the printer, contact your network administrator.
A Press {U} or {T} until the fol- lowing message appears.
E Repeat steps C and D to enter the IP address.
IP Address: 192.168.000.011
Check if the pointer (k) is at the rightmost position, and press {Enter #} to register the IP ad- dress you selected.
Network Setup:
IP Address
BPress {Enter #}.
The current IP address appears on the panel display.
IP Address: 011.022.033.044
C Press {U} or {T} to enter the left most entry field of the IP address.
IP Address: 192.022.033.044
DPress {Enter #}.
The pointer (k) moves to the next entry field automatically.
IP Address: 192.02k.033.044
Note
❒The value moves by 10 if {U} or {T} is kept pressed.
❒You can return the pointer (k) to the previous (left) entry field by pressing {Escape}.
❒If you press {Escape} when the pointer (k) is on the left- most position, the selected IP address is reset.
Network Setup:
IP Address
H If you use TCP/IP, assign “Subnet Mask” and “Gateway Address” following the same procedure for entering the IP address.
I If you use TCP/IP, you can make settings for “Network Boot”.
You can select how to assign the printer's address using the compu- ter. Select one of the items below if necessary.
•None (Default)
•DHCP
A Press {U} or {T} to display “Network Boot”.
Network Setup:
Network Boot
BPress {Enter #}.
The current setting appears on the panel display.
Network Boot: *None
C Press {U} or {T} to display the method you want to use.
DPress {Enter #}.
3
43