2Grasp the handles on the toner cartridge and pull to remove the cartridge from the machine.
Caution
If you open the front door, be careful not to touch the underneath of the control panel (the lower part of the fuser unit). The temperature of the fuser unit might be high and could damage your skin.
Note
When you open the front door and work inside the machine, it is highly recommend that you remove the paper transfer belt first. Because the work you do could contaminate the paper transfer belt.
3Holding both handles on the toner cartridge, thoroughly rock it from side to side to redistribute the toner.
Note
If toner gets on your clothing, wipe it off with a dry
cloth and wash it in cold water. Hot water sets toner into fabric.
4Slide the toner cartridge back into the machine.
5Close the front cover. Make sure the cover is securely latched.
Caution
If the front cover is not completely closed, the machine will not operate.
Replacing the toner cartridge
The machine uses four colors and has a different toner cartridge for each one: yellow (Y), magenta (M), cyan (C), and black (K).
•The status LED and the
At this stage, the toner cartridge needs to be replaced. Check the type of toner cartridge for your machine. (See "Supplies" on page 8.1.)
1Turn the machine off, then wait a few minutes for the machine to cool.
2Using the handle, completely open the front cover.
Caution
•Do not touch the green surface, the OPC drum or the front of each toner cartridge, with your hands or any other material. Use the handle on each cartridge in order to avoid touching this area.
•Be careful not to scratch the surface of the paper transfer belt.
•If you leave the front cover open for more than a few minutes, the OPC drum can be exposed to light. This will cause damage to the OPC drum. Close the front cover should the installation need to be halted for any reason.