Mitsubishi Electronics WD-60C8 manual Initial TV Setup, Setting Up TV Inputs, Memorizing Channels

2. TV Setup 13

Initial TV Setup

Use the Setup menu for basic TV setup options.

1.Press MENU to open the Main menu.

2. Press to highlight the Setup icon and display the Setup menu.

Memorizing Channels

For ANT 1 and ANT 2

To start channel memorization

1. With the Setup menu displayed, press to high- light the Scan icon.

Start channel memorization from the Setup menu.

2. Press	to highlight an input selection based on
your connections:
Input		Condition
Ant 1 Air		When connected to an indoor or
Ant 2 Air		outdoor antenna
Ant 1 Cable		When connected to direct cable (no
Ant 2 Cable		cable box)

3.Press to highlight the on-screen START button.

4.Press ENTER to start automatic channel memoriza- tion.

To stop channel memorization before completion, press CANCEL.

5.When memorization is complete you can:

•Press MENU once to return to the top row of icons.

•Press MENU again to return to the Main menu.

•Press EXIT to watch TV.

After channels have been memorized:

•To tune to memorized channels, press CH  / while watching TV on the ANT 1 or ANT 2 inputs.

•Use the Setup > Edit menu (page 44) for additional channel options, such as adding or deleting chan- nels from memory, naming channels, and saving favorite channels in custom memory banks.

See chapter 5, “TV Menu Settings,” to:

•Set the TV clock (page 45)

•Set the TV Timer (page 46)

•Select an Energy Mode to manage power use while the TV is off (page 47)

•Select a lamp brightness mode (page 47)

•Enable 3D video (pages 35 and 47)

Setting Up TV Inputs

When You First Connect a Device

The TV’s Easy Connect™ Auto Input Sensing feature detects most connections automatically.

Note: For connection and setup of a personal com- puter, see the information on page 17.

Auto Input/Auto Output Sensing for Most Devices

When you first connect a device, the TV will:

a.Detect the connected device and automatically switch to it

b.Prompt you to identify the device type

c.736 or 835 series TV. Prompt you to perform NetCommand set-up for the device, if available.

d.Repeat these steps for any additional newly detected devices

See below for connections which trigger Auto Sensing.

Auto Input Sensing Available

Y/VIDEO (detected as composite video)

Y plus Pb (detected as component video)

S-VIDEO

HDMI *

USB (USB photo port on front)

InPUT 4 AUDIO (for an audio-only device; see page 25.)

Auto Output Sensing Available

Digital Audio OUTPUT (orange jack)

AVR AUDIO OUTPUT (red jack)

No Auto Sensing

ANT 1 and ANT 2

*If the device is powered off when connected, detec- tion occurs when the device is next powered on.

Auto Input/Auto Output Sensing for CEC Devices

When the TV’s NetCommand for HDMI feature is active, most CEC-enabled devices are recognized and identified automatically by the TV. NetCommand for HDMI may allow you to control functions of a CEC-enabled device. See Appendix E, “NetCommand HDMI Control of CEC Devices,” page 77.