Mitsubishi Electronics WD-60C8 manual Using NetCommand Hdmi Control

Appendices79

Resolving CEC Conflicts, Changing HDMI Connections, Removing HDMI Devices

Because each manufacturer selects which CEC func- tions to support, some devices can conflict with other devices. If control conflicts arise, you can:

•Turn off CEC in the other device’s setup menu.

•Turn off TV control of an individual CEC device (see fiugre 5 below).

•Reset TV control of an individual CEC device (see figure 6 below).

Turning Off the TV’s HDMI Control of an Individual CEC Device (Figure 5)

1.Press MENU on the TV remote control to enter the TV Main menu.

2.Select the Inputs menu using the keys.

3.Select the Inputs > Name menu using the key.

4.Highlight the device to remove using the key and then the key.

5.With the device highlighted, select Control Off to turn off the TV’s ability to control the device.

6.Press EXIT to clear the menus.

Figure 5. Inputs > Name menu with HDMI Control for AVR Tuner turned off

Resetting HDMI Control or Removing an HDMI Device (Figure 6)

1.Power off the device.

2.If removing the device, disconnect the HDMI cable.

3.Press MENU on the TV remote control to enter the TV Main menu.

4.Select the Inputs menu using the keys.

5.Select the Inputs > Name menu using the key.

6.Highlight the device to reset using the key and then the key.

7.With the device highlighted, select Delete to reset HDMI Control.

8.Press EXIT to clear the menus.

If the device is still connected, the Auto Input Sensing screen will display.

Figure 6. Inputs > Name menu with AVR DVD deleted.

Using NetCommand HDMI Control

As an example of using NetCommand for HDMI devices, you would press PLAY on the device itself to:

•Turn on the TV if not already on

•Switch to the device (no need to display the Input Selection menu)

•Begin play of the device

Test your equipment with the TV’s remote control to find out which commands are supported. See the table below for commands that may be available, depending on the individual device.

CEC-enabled VCR, DVD, and DVR functions that may be available:

Record/	Menu	Channel Tuning		Other
Playback	Navigation
		CH	/	Guide
	Enter		—	F1 (content)*
	—	Digits 0–9, CANCEL
			ENTER	MENU
	CANCEL
	(to cancel)

*The F1 key defaults to work like the device’s LIST key.

If you have a CEC-enabled A/V receiver, CEC-enabled devices connected to the A/V receiver with an HDMI cable may also be controllable. They can be selected from the TV’s Input Selection menu.

CEC-enabled A/V receiver functions that may be available:

•Try the VOL, MUTE, and menu-navigation keys.

•To open the A/V receiver menu, follow these steps:

1.While watching TV, press AUDIO.

2.Press repeatedly until the Speakers option displays.

3.While Speakers is still displayed, press MENU.

736 or 835 Series TV. You can use NetCommand IR “learning” to add commands to those supported by CEC. You must first connect and place IR emitters for the devices.