Mitsubishi Electronics WD-60C8 manual Choosing a Viewing Source, Sleep Timer, TV Tips

Highlight an input icon using

26 4 TV Operation and Features

Choosing a Viewing Source

Input Selection menu

Choose a viewing source from the Input Selection menu. The current TV input appears as a full-color icon in this menu.

1.Press INPUT to display the Input Selection menu. If there are only two inputs to the TV, INPUT switches between them without displaying the menu.

2..

3.Press ENTER to switch to the input and close the menu.

More About the Input Selection Menu

•To assign meaningful names to the icons, see the

Inputs > Name menu, page 48.

•To rearrange the icons, see the Inputs > Order menu, page 48.

Sleep Timer

The Sleep Timer turns the TV off after the length of time you set. To set the TV to turn on at a certain time, see the Setup > Timer menu on page 46.

Setting the Sleep Timer

1.Press SLEEP on the remote control.

2.Press SLEEP additional times to increase the time in 30-minute increments up to the maximum of 120 minutes.

3.Press EXIT or wait five seconds without pressing any keys for the message to disappear.

4.Press SLEEP to view the time remaining before the sleep timer turns off the TV.

Cancelling the Sleep Timer

1.Press SLEEP to display the on-screen message.

2.Press SLEEP repeatedly until OFF is displayed.

Note: After five seconds of inactivity, the message box will disappear.

TV Tips

Turning the TV On or Off

To turn the TV on or off, point the remote control at the front of the TV and press the POWER button. Alterna- tively, press the POWER button on the control panel of the TV.

If You Turn Off the TV by Mistake

1.Press POWER again within about 60 seconds (while the lamp is still hot) to have the TV come back on immediately.

2.If the LAMP indicator starts blinking (about 60 seconds after you shut off power), wait a few moments for the LAMP indicator to stop blinking and press POWER to turn the TV on again.

Controlling Sound Volume

•Press VOL  / to adjust the sound level.

•See also “Controlling A/V Receiver Sound Volume” on page 15.

Changing Channels (antenna sources)

To change channels:

• Enter the channel number using the number keys on the remote control and press ENTER. For a two-

part digital channel, such as 3-1, press 3 — 1

CANCEL

to enter a dash (separator).

•	Press CH/PAGE	/  to change channels one
	channel at a time.
•	Press and hold	CH/PAGE  /  to move quickly
	through channels.

•Press QV (QuickView) to switch back to the previ- ously tuned channel.

•Press GUIDE to display ChannelView channel listings, highlight a channel, and press ENTER to select.

•Use the Fav (Favorites) feature to set up lists of favorite channels and tune to them with the FAV key. See Setup > Edit > Fav 1–Fav 6 on page 44.

NOTE: Perform channel memorization to make finding channels easier. See Setup > Scan, page 43.