Mitsubishi Electronics WD-60C8 Installation Notes, Internal Fans, Lamp Replacement, TV Software

Page 4

4

Important Information About Your TV

Installation Notes

Stand Requirement

CAUTION: Use these Mitsubishi TV models only with the Mitsubishi stand models shown here. Other stands can result in instability and possibly cause injury.

TV Model

Stand Model

WD-60C8, WD-60735,

 

WD-65C8, WD-65735,

MB-S60/65

WD-65736

 

WD-73C8, WD-73735

MB-S73

WD-73736

 

 

 

835 Series Stands: Mitsubishi does not design, manufac- ture or sell matching bases for 835 series model televisions (WD-65835, WD-73835). When selecting a stand, base or other furniture to support the TV, please make sure it is designed with the appropriate dimensions for stability and to support the TV’s total weight as well as the weight of any addi- tional equipment you plan to store.

Custom cabinet installation must allow for proper air circulation around the television.

NOTE TO CATV SYSTEM INSTALLER: THIS REMINDER IS PROVIDED TO CALL THE CATV SYSTEM INSTALLER’S ATTEN- TION TO ARTICLE 820-40 OF THE NEC THAT PROVIDES GUIDE- LINES FOR THE PROPER GROUNDING AND, IN PARTICULAR, SPECIFIES THAT THE CABLE GROUND SHALL BE CONNECTED TO THE GROUNDING SYSTEM OF THE BUILDING, AS CLOSE TO THE POINT OF CABLE ENTRY AS PRACTICAL.

Internal Fans

Internal cooling fans maintain proper operating tempera- tures inside the TV. It is normal to hear the fans when you first turn on the TV, during quiet scenes while viewing the TV, and for a short time after shutting off the TV. You may notice louder fan noise about 30 seconds after shutting off the TV and while using the Bright Lamp Mode.

Lamp Replacement

For lamp-replacement instructions, see Appendix D.

To Order a Replacement Lamp Under Warranty Call (800) 553-7278. Please have model number, serial number, and TV purchase date available.

Important: All lamps replaced under warranty must be returned to Mitsubishi where they will be inspected for defect verification.

To Purchase a Replacement Lamp After Warranty

Visit our website at www.mitsuparts.com or call

(800)553-7278. Order new lamp part number

915B403001.

TV Software

Do not attempt to update the software of this TV with software or USB drives not provided by or authorized by Mitsubishi Digital Electronics America, Inc. Non-authorized software may damage the TV and will not be covered by the warranty.

Cleaning Recommendations

Normally, light dusting with a dry, non-scratching duster will keep your TV clean. If cleaning beyond this is needed, please use the following guidelines:

First, turn off the TV and unplug the power cord from the power outlet.

Occasionally clean dust build-up from the air-intake grilles on the back and sides of the TV. Clean using a vacuum cleaner with a brush attachment.

Top and Sides of the TV

Gently wipe down your TV with a soft, non-abrasive cloth such as cotton flannel or a clean cloth diaper, lightly moistened with water. Dry with a second dry, soft, non-abrasive cloth.

For oily dirt, add a few drops of mild liquid detergent, such as dishwashing detergent, to the water used to moisten the cloth. Rinse with a second cloth moist- ened only with water. Dry with a third dry, soft, non- abrasive cloth.

Glossy Surfaces (835 series models)

Use the soft cleaning cloth supplied with the TV.

Clean the cloth before each use by shaking or brush- ing to remove any residual dirt particles.

Gently wipe down the glossy surfaces of your TV with the soft cloth. Do not apply pressure while wiping.

If necessary, lightly dampen the soft cloth with water.

Do not use chemical or abrasive cleaners.

Wash the soft cloth by hand or machine. Use only mild soap.

Screen

Follow the instructions for the top and sides, wiping gently in an up and down motion.

Clean the entire screen evenly, not just sections of the screen.

Do not allow liquid to drip down the screen, as some liquid may enter the TV through the gap between the screen and screen frame.

You may purchase Mitsubishi Screen Cleaner, part number CLEANER-VSS, by calling (800) 553-7278.

General Cleaning Precautions

DO NOT allow liquid to enter the TV through the venti- lation slots or any crevice.

DO NOT use any strong or abrasive cleaners, as these can scratch the surfaces.

DO NOT use any cleaners containing ammonia, bleach, alcohol, benzene, or thinners, as these can dull the surfaces.

DO NOT spray liquids or cleaners directly on the TV’s surfaces.

DO NOT scrub or rub the TV harshly. Wipe it gently.

Image 4
Contents WD-60C8, WD-65C8, WD-73C8 WD-60735, WD-65735, WD-73735WD-65736, WD-73736 WD-65835, WD-73835Refer Servicing to Qualified Service Personnel For Your RecordsContents Installation Notes Lamp ReplacementCleaning Recommendations Internal FansReplacement Parts Outdoor Antenna GroundingPackage Contents Special Features of Your TVControl Panel TV Front PanelFront Inputs Front-Panel Indicators POWER/TIMER IndicatorStatus Indicator Lamp IndicatorTV Back Panel ANT 1/ANT 2 AntennaComposite Video Input 1, Input Component Video Input 1, InputIR NetCommand Output/External Controller Input Hdmi Inputs High-Definition Multimedia InterfaceAudio L and R Input 1, Input Hdmi Cable CategoriesWhen You First Power On the TV Guidelines for Setting Up and Using Your New Widescreen TVInstalling the Remote Control Batteries Additional TV Setup TV OperationTV Care AssistanceInitial TV Setup Setting Up TV InputsWhen You First Connect a Device Memorizing ChannelsSetup Procedure Setup Procedure for TV Inputs Disconnecting an Analog A/V ReceiverAuto Input/Auto Output Sensing Screens Tips on Auto Sensing and Changing Connected DevicesControlling A/V Receiver Sound Volume With a Standard TV SetupWith NetCommand IR Control With NetCommand for Hdmi CEC-Enabled Hdmi A/V ReceiverSource device connected directly to the TV Connecting a Computer to the TV This TV accepts digital computer signals only  Computer Video Connection Audio Video OutputUsing the TV with a Personal Computer Computer Video AdjustmentsImage Resolution Computer Display FormatsBefore You Begin Auto Input SensingConnection Types Picture QualityHdmi and Audio Signals 065Antennas with Separate UHF and VHF Leads Wall Outlet Cable no cable boxAntenna with a Single Lead 57CBDLQBOFM ODPNJOH DBCMFGSPN Xbmm VCR to an Antenna or Wall Outlet CableVCR VCR to a Cable Box Audio & Video Older Cable BoxAudio Video from Cable box To TVReceiver Sound System Using the TV’s Audio Output Receiver with Hdmi Output7SFDFJWFSCBDLQBOFM DVD playerCamcorder Audio-Only DeviceChoosing a Viewing Source Sleep TimerTV Tips Remote Control Adjust Up/Down/Left/Right Navigate menus and change settingsResetting the Remote Control Low-Battery IndicatorCare of the Remote Control Record/Playback KeysUsing ChannelView FeatureChannelView Channel Listings Press KeyStatus Display Ant 1TV-PG On-screen status displayFav Favorite Channels ANT-1TV Signals and Display Formats Signal DefinitionsDVD Image Definitions TV Display Format DefinitionsViewing Camera Files Jpeg Photos and the USB Photo PortMain menu USB Photo menuMedia Setup Menu Photos and Moving Video as Composite VideoSlide Show Keys for Jpeg Picture Slide Show3D Video Initial Set-UpTo Watch 3D Video To Watch Regular non-3D VideoRemote Control Keys for the TV Menu System Main MenuAV Menu AV Menu OptionsFilm Mode Auto, Off Video Mute On, OffGlobal Audio Only On, OffVideo Menu Video Menu OptionsVert Adjustment SharpEdge On, OffDeep Field ImagerAudio Menu Audio Menu OptionsANT1/ANT2 SAPCaptions Menu Captions on Analog ChannelsCaptions on Digital Channels Captions Menu OptionsSetup Menu Options Setup Menu1 Enter Setup menu, Edit channel options EditSetup menu, Clock options Timer Setup menu, Timer optionsEnergy Fast Power On Mode Low Power When Inputs NetCommand Hdmi Inputs MenuInputs Menu Options Selection menuLock Menu Pass CodesParent Menu Other Menu Alternate Rating SystemParent Menu Options U.S.-based rating system TV-YTV-Y7 TV-GOther Menu Options alternate rating system TimeAbout NetCommand IR Control Important Note on NetCommandIR Emitter Placement An IR emitter cable is included with the TVInitial NetCommand Setup for Most Devices If the device has no Power OFF key, skip this stepGuide PowerCH/PAGE Controlling Most Device Types Operating NetCommand-Controlled DevicesSpecial Operation Methods Controlling an A/V Receiver Inside the Guide Outside the GuideSetting Up NetCommand Control of an A/V Receiver Receiver Control Power and VolumeSetup to Control A/V Receiver Power and Volume Before You BeginAudio Switching Setup 1 Audio from TV’s Audio Output Receiver Control Automatic Audio SwitchingAudio Switching Setup 2 Audio from Source Device AV Receiver menu to set up audio switching Open the Inputs AV Receiver menuMore About Using an Hdmi Connection Setup to Control Switching to the TV’s Audio Output TV back panel Optional Analog orDigital audio With Hdmi Connection Display the Inputs AV Receiver menuNetCommand IR Control Device Connected to an A/V Receiver Ated Assign Input column Assign Input1 throughAssign Input5 Open the Inputs Learn menuAppendix a Specifications Depth Lbs WattsAppendix B Bypassing the Parental Lock Bypassing the Parental LockThis page intentionally left blank Appendix C Programming the Remote Control Functions Available for Other A/V DevicesProgramming the Remote Control DVDCABLE/SAT VCR DVD Audio Code VerificationProgramming Codes Make CodeCable Boxes Make Code CD Players Make CodeLaser Disc Players Make Code Receivers Make CodeSatellite Receivers Make Code Satellite ReceiversVCRs Make Code KEC DVD Players Make Code SVAIRT Appendix D Lamp-Cartridge Replacement and Cleaning Lamp LifeTo Order a New Lamp Lamp Part Number 915B403001Lamp-Cartridge Replacement Lamp-Cartridge Filter CleaningInstalling the New Lamp Cartridge Removing the Old Lamp CartridgeEnabling or Disabling the TV’s NetCommand Hdmi Control Appendix E NetCommand Hdmi Control of CEC DevicesConnecting Hdmi Devices to the TV NetCommand Hdmi Control is off Resetting Hdmi Control or Removing an Hdmi Device Figure Using NetCommand Hdmi ControlCEC-enabled A/V receiver functions that may be available TV Reset Comparison Guide Appendix F TroubleshootingReset Name When to Use How to Use Resulting Action Service Service and Customer SupportCustomer Support General TV Operation Symptom Remarks TV Channels Symptom Remarks TV Power On/Off Symptom RemarksPicture Symptom Remarks Symptom Remarks Indicators Symptom RemarksNetCommand IR Control Symptom Remarks Appendix F Troubleshooting Trademark and License Information Mitsubishi TV Software Mitsubishi DLP Projection Television Limited Warranty Warranty91 Index Index93 MDEAservice@mdea.com System Reset
Related manuals
Manual 71 pages 26.25 Kb Manual 71 pages 21.97 Kb