Mitsubishi Electronics WD-60C8 manual Record/Playback Keys, Resetting the Remote Control

284. TV Operation and Features

Remote Control, continued

21.MENU: Displays the main TV menu. When a sub- menu is open, backs up one menu level.

22.EXIT: Closes TV on-screen menus/displays.

23. F1–F4

For devices under NetCommand control: Perform NetCommand “Learning” to assign your choice of functions to the F1–F4 keys.

For devices operating independently of NetCommand: The F1–F4 keys work like the A, B, C, D buttons on some cable boxes, satellite receivers, and DVD players. Program the remote control for your equipment and test the keys. See Appendix C, “Programming the Remote Control.”

25. (Pause): Freezes a broadcast TV picture from an antenna source, cable box, or satellite receiver (if key has not been reassigned for NetCommand use).

Record/Playback Keys

Use any of these methods to enable the recording and playback commands of the TV’s remote control:

•Program the remote control for your DVR, VCR, or

DVD player/recorder and set the slide switch to VCR, DVD, CABLE/SAT, or AUDIO as appropriate.

•Check HDMI devices for compatibility with the TV’s

NetCommand for HDMI feature (see Appendix E).

•736 or 835 Series TV: Perform NetCommand IR “learning” for the device.

24. (Record): Records with a VCR or DVR.

25. (Pause): Pauses a VCR, DVR, or DVD. See above for use during TV viewing.

26. (Stop): Stops play of a VCR, DVR, or DVD.

27. (Reverse): Rewinds a VCR. Reverse scans a DVR or DVD.

28. (Play): Plays a VCR, DVR, or DVD.

29. (Forward): Fast forwards a VCR. Forward scans a DVR or DVD.

Note: To operate other audio/video devices using the TV’s remote control:

•See Appendix C, “Programming the Remote

Control.”

•For HDMI devices compatible with the TV’s Net- Command for HDMI feature, see Appendix E.

•736 or 835 Series TV: See chapter 6, “NetCom- mand IR Control,” for NetCommand IR “Learning” of device keys.

•For use of specific keys with NetCommand-con- trolled devices, see “Special Operation Methods,” page 56.

Resetting the Remote Control

If the slide switch is set to TV and the TV does not respond properly, reset the remote control.

1.Press and hold POWER for several seconds until the button blinks twice and goes off.

2.Release the POWER button.

3.Press keys 0 0 9 3 5 and the POWER button will blink twice when you finish entering the code. While entering the code, pause for a moment between each key press to ensure it is recognized.

Low-Battery Indicator

If you press a key and the POWER key blinks five times, replace the remote control’s batteries.

Care of the Remote Control

•Use only alkaline batteries.

•Be within 20 feet of the equipment.

•Do not press two or more buttons at the same time unless instructed to do so.

•Do not allow unit to get wet or become heated.

•Avoid dropping on hard surfaces.

•Do not use harsh chemicals to clean. Use only a soft, lightly moistened cloth.

•Do not mix old and new batteries.