■Setting this unit to delay the boot up time
Because the unit searches for connected devices when power is turned on, peripheral devices must be turned on before power is turned on to the digital recorder.To handle peripherals which take a long time to start up, the unit can be preset to delay the timing of its search for these devices.
1.Press the POWER button while pressing the REC button to turn the power on.
•The <DEVICE CHECK> menu will appear.
<DEVICE CHECK> |
|
SCSI ID0:HDD( 60GB) |
|
ID1:NONE |
|
ID2:NONE |
|
ID3:NONE |
|
ID4:NONE |
|
ID5:NONE |
|
@INITIALIZE ALL HDD | 00 |
BOOT UP DELAY |
2.Turn the JOG dial to select BOOT UP DELAY, and turn the SHUTTLE ring to the right.
•The
ID5:RDD |
|
INITIALIZE ALL HDD | 00 |
@BOOT UP DELAY |
3.Turn the JOG dial to set the delay time, and turn the SHUTTLE ring to the right to enter the selection.
•You can set up to 99 seconds.
ID5:RDD |
|
INITIALIZE ALL HDD | 10 |
@BOOT UP DELAY |
When BOOT UP DELAY is set and timer recording is performed, the unit will begin recording later than
the time set as the recording time.
4.Press the POWER button.
•The power of this unit will be turned off.
5.Press the POWER button again.
•This unit will start setting up after the preset delayed time has passed.
If a different peripheral recording device was con- nected from the last time the unit was booted up, the
<DEVICE CHECK> menu will appear.
ENGLISH |
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• | Initial settings |
21