110 |
| TROUBLESHOOTING (cont.) | |
RECORDING |
|
| |
|
|
|
|
| SYMPTOM | POSSIBLE CAUSE | CORRECTIVE ACTION |
1. | The desired programme cannot be | ● The channel position does not | Set the correct channel position for the |
| recorded. | correspond to that in the receiving area. | receiving broadcast. ( pg. 98) |
|
|
|
|
2. | Recording cannot be made. | ● No disc or a disc not being compatible | Load a recordable disc on the unit. |
|
| with the unit is loaded. | ( pg. 6) |
|
| ● The disc loaded is not formatted. | Format the disc. ( pg. 106) |
|
| ● A finalised | Recording cannot be made on finalised |
|
|
| discs. ( pg. 107) Load a recordable disc |
|
|
| on the unit. |
|
| ● The disc is full or does not have enough | Clear unnecessary programmes on the |
|
| space for the programme to be recorded. | disc or load a blank disc. ( pg. 71) |
|
|
|
|
3. | Timer programming cannot be made. | ● Date and time is not correct. | Set date and time correctly. ( pg. 104) |
|
|
|
|
4. | Timer programming recording does not | ● Power failure occurred before the timer | Check the timer programming. ( pg. 63) |
| start. | programmed recording starts. |
|
|
|
|
|
5. | VIDEO Plus+ Timer Programming | ● Date and time set on the unit is not | Set date and time correctly. ( pg. 104) |
| cannot be made. | correct. |
|
|
| ● The channel position does not | Set the correct channel position for the |
|
| correspond to that in the receiving area. | receiving broadcast. ( pg. 98) |
|
|
|
|
6. | Automatic Satellite Programming | ● The satellite receiver is not connected | Connect the satellite receiver to the |
| recording does not start. | properly to this unit. | IN/DECODER connector properly. |
|
|
| ( pg. 90) |
|
|
|
|
7. | On the front display panel, “– | ● Power failure occurred. | Set date and time correctly. ( pg. 104) |
| appears. |
|
|
|
|
|
|
8. | “PROGRAM FULL” appears on the TV | ● Eight programmes have already been | Clear unnecessary programmes on the |
| screen during timer programming. | timer programmed. | unit, then try timer programming again. |
|
|
| ( pg. 63) |
|
|
|
|
9. | The disc space does not increase when | ● The PC’s data recorded on a | Format the disc. (When the disc is soiled, |
| recorded programmes are cleared. | drive cannot be cleared on this unit. | wipe the disc with a soft dry cloth before |
|
|
| formatting.) ( pg. 10, 106) |
|
|
| |
INITIALIZING |
|
| |
|
|
|
|
| SYMPTOM | POSSIBLE CAUSE | CORRECTIVE ACTION |
1. | Malfunction occurs on the unit. |
| Press 1 to turn off the unit, press and |
|
| — | hold 1, then press 8 for two seconds or |
|
|
| more. |
|
|
|
|
ATTENTION:
This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the unit off and unplug the mains power cord. Then plug it in again and turn the unit on. Take out the disc. After checking the disc, operate the unit as usual.