81
A Make connections.
Connect a camcorder or DV equipment to the DV IN connector on the unit’s front panel.
B Prepare the unit for dubbing.
ALoad a
disc on the unit.
B Press PR +/– to set the channel to “DV DUBBING”.
● The “DV DUBBING” controller appears on the TV screen.
CPress w e to move 0 to , then press
ENTER.
DPress rt repeatedly to select the desired sound track, then press ENTER.
AUDIO 1: Select this to record the original stereo sound played back on the connected DV equipment.
AUDIO 2: Select this to record the dubbed stereo sound played back on the connected DV equipment.
MIX: Select this to record the sound of both “AUDIO 1” and “AUDIO 2”.
●Note that this selection is not available when the source programme is recorded in 16BIT (48 kHz) mode.
EPress REC MODE repeatedly until the desired recording speed appears. ( pg. 54, “Recording Speed”)
C Prepare the DV equipment for dubbing.
Locate the point from where you want to start dubbing, then stop or pause playback by pressing the following buttons on the remote control:
4, 5, 3, 8, 9
●To play back in slow speed (1/10 of the normal speed), press 9 to pause playback, then press 3 or 5.
●To play back
●To change the playback direction, press 3 or 5.
D Start dubbing.
Press w e to move the arrow to , then press
ENTER.
●Playback on the external DV equipment and recording on the unit should start simultaneously.
●When the playback from the beginning is not possible, the
“DV DUBBING” controller cannot be used. Perform dubbing without using the “DV DUBBING” controller. ( right column)
●To pause dubbing, press w e to move 0 to , then press ENTER. Both the unit and the external DV equipment pause dubbing. Pressing 9 on the unit also works the same way.
●To clear the “DV DUBBING” controller from the TV screen, press PLAY SET UP.
E Stop dubbing.
Press 8 on the remote control.
NOTES:
●Dubbing copyright guarded programmes is not possible.
●Original DV informations such as the recording date and time are not recorded.
●The superimposed indication during the operation or dubbing is not recorded.
●The “DV DUBBING” controller disappears if SET UP or other buttons are pressed. To display the “DV DUBBING” controller again, press PLAY SET UP on the remote control.
Performing dubbing without using the “DV DUBBING” controller
APress PR +/– to set the channel to “DV DUBBING”.
BPress REC MODE repeatedly until the desired recording speed appears.
CStart playback on the external DV equipment slightly before the actual point from where you wish to start dubbing.
DPress and hold 7, then press 4 on the remote control, or press 7 on the unit.
●Dubbing starts.
EWhen the dubbing ends, press 8 on the unit, then stop playback on the external DV equipment.
●Both the unit and the external DV equipment stop dubbing.