Sun Microsystems X6450 manual Using the -Select Utility to Modify REM Settings

Using the -Select Utility to Modify REM Settings

The BIOS RAID Configuration utility includes a tool for modifying the settings of the REM and the disk drives connected to it. This utility is called SerialSelect or SATASelect. This section contains the following subsections:

■“To Start Using a -Select Utility” on page 53

■“To Apply Changes and Exit a -Select Utility” on page 53

■“To Modify General Settings With a -Select Utility” on page 54

■“To Modify SAS-Specific REM Settings With a -Select Utility” on page 55

▼To Start Using a -SelectUtility

1.Start the BIOS RAID Configuration utility (see “To Start the BIOS RAID Configuration Utility” on page 48).

The ARCU screen appears.

2.Select the -Selectutility and press Enter.

3.Follow the on-screen instructions to modify the settings of the REM and connected disk drives, as required.

▼To Apply Changes and Exit a -SelectUtility

1.Press Esc until you are prompted to exit.

If you modified any settings, you are prompted to save the changes before you exit.

2.Select Yes to exit, then press any key to restart your computer. Any changes you made take effect after the computer restarts.

Appendix B Using the BIOS Configuration Utility to Configure the Sun Blade RAID 5 Expansion Module 53