JVC DR-MV5SEK, DR-MV5BEK manual To DVD, Auto Recording Mode Optimizer, Auto Title Creation Dubbing

Filename [MV5SEK_08Basic TimerDub.fm]
MV5SEK_00.book Page 37 Wednesday, August 31, 2005 7:58 PM						Masterpage:Right0
One-Touch Expert Dubbing (From VHS						EDITING EN 37
						The unit calculates the total recording time of the VHS tape and
To DVD)						Auto Recording Mode Optimizer
						automatically selects the optimum DVD recording mode.
						Auto Title Creation Dubbing
						Each index code (VISS signal) on the VHS tape is detected and
● Turn on the unit.						created as a title on the DVD disc. When a tape contains multiple
● Turn on the TV and select the AV mode.						VISS signals, separate titles are created for each VISS signal
● Slide the TV/DVD switch to DVD.						(for each programme).
● Make sure that both the DVD deck and the VHS deck are in the						Auto Blank-Cut Dubbing
stop mode.						Recording to the DVD pauses during blank sections on the VHS
			VHS			tape and restarts when a signal is detected.
						1 For DVD deck
						Load a recordable disc.
						● Load an empty disc. If a disc with recorded data is loaded, the time
			VHS/DVD		PR	calculation will not include the recorded section, and so dubbing may
STANDBY/ON		VHS	DVD		REC
S-VIDEO	VIDEO	AUDIO			DV IN	not be possible for an entire tape.
			VHS	DUBBING	DVD
						For VHS deck
						Load a cassette you want to dub.
						2 Press and hold VHS] for more than 2 seconds to start
						dubbing.
						● The unit fast-forwards and rewinds the tape to calculate the recording
						time, then starts dubbing after setting automatically the recording
						mode that enables recording to fill exactly one disc. It takes a few
						minutes to calculate the recording time.
						● After dubbing is completed, the VHS deck rewinds the tape
						automatically and the unit shuts off.
						● To cancel dubbing, press VHS] again so that “]” lights off.
						● To stop dubbing, press 8.

Stop and pause mode on the DVD deck

When recording, the unit automatically searches for the blank section of the disc no matter where the disc was stopped or paused.

In contrast to VHS tapes, recorded sections on discs cannot be overwritten.

NOTES:

● When you turn on the unit next time, press VHS] so that “]” lights off before performing any operations. If it is not done, recording on the DVD deck is not possible.

● It is not possible to dub a tape with a copy protection signal.

● If there is no remaining recording time left on a DVD disc, the tape automatically stops at that position.

● It is not possible to perform other operations like Live Memory Playback. Check the recorded programme on the disc after dubbing.

● It is not possible to perform dubbing on the On-Disc Timer programmed disc. Either cancel the disc programming, or use an unprogrammed disc.

● If the index code (VISS signal) is found on a tape during One-Touch Expert Dubbing, a single title is created. While creating a title, the dubbing stops. Dubbing starts again once the title is created. When a tape contains multiple VISS signals, separate titles are created for each VISS signal.

● During still picture on the VHS deck, the images may jitter, but this is not a malfunction.

Page 37Wednesday, 31 August 2005 19:58