Filename [MV5SEK_13Subsidiary.fm] |
|
MV5SEK_00.book Page 92 Wednesday, August 31, 2005 7:58 PM | Masterpage:Left+ |
|
92 EN TROUBLESHOOTING
Playback (VHS Deck)
The VHS deck cannot be operated.
●The VHS deck is not selected.
]Press VHS/DVD on the unit repeatedly or VHS on the remote control so that the VHS lamp lights up on the unit.
The tape will not rewind or
●The tape is already fully rewound or
The playback picture does not appear while the tape is running.
●The TV receiver’s channel selector is not set to the AV mode. ]Set the TV to its AV mode.
Noise appears during visual search.
●This is normal.
Noise appears during normal playback.
●The automatic tracking mode is engaged. ]Try manual tracking. ( pg. 60)
The playback picture is blurred or interrupted while TV broadcasts are clear or “USE CLEANING CASSETTE” message appears on the screen.
●The video heads may be dirty.
]Use a dry cleaning cassette, or consult your JVC dealer.
Breaks are noticeable in
●The automatic tracking mode is engaged. ]Try manual tracking. ( pg. 60)
Recording (DVD Deck)
The desired programme cannot be recorded.
●The channel position does not correspond to that in the receiving area.
]Set the correct channel position for the receiving broadcast. ( pg. 85)
Recording cannot be made.
●No disc or a disc not being compatible with the unit is loaded. ]Load a recordable disc on the unit. ( pg. 6)
●The disc loaded is not formatted.
]Format the disc. ( pg. 89)
●A finalised
]Recording cannot be made on finalised discs. Load a recordable disc on the unit.
●The disc is full or does not have enough space for the title to be recorded.
]Clear unnecessary titles on the disc or load a blank disc. ( pg. 67)
Recording (VHS Deck)
During recording, the tape does not run. The VHS recording lamp lights up on the unit.
●The unit is in the Record Pause mode. ]Press 4 to resume recording.
Recording cannot be done.
●There is no cassette loaded, or the cassette loaded has had its
record safety tab removed.
]Insert a cassette, or using adhesive tape, cover the hole where the tab was removed.
TV broadcasts cannot be recorded.
●
Camcorder recording is not possible.
●The camcorder has not been properly connected. ]Confirm that the camcorder is properly connected.
●The input mode is not correct.
]Set the input mode to
The tape is automatically stopped and “[’’ on the front display panel won’t stop blinking.
●The end of the tape was reached during recording.
]The programme may not have been recorded in its entirety. Next time make sure you have enough time on the tape to record the entire programme.
Timer Recording (DVD Deck)
“NO DISC” appears on the front display panel.
●No disc is loaded.
]Press TIMER # so that the DVD timer lamp lights off. Load a recordable disc, then press TIMER # again.
Timer programming cannot be made.
●Date and time is not correct.
]Set date and time correctly. ( pg. 88)
●Timer recording is in progress.
]Timer programming can’t be performed while a timer recording is in progress. Wait until it finishes.
Timer programming recording does not start.
●Date and time is not correct.
]Set date and time correctly. ( pg. 88)
VIDEO Plus+ Timer Programming cannot be made.
●Date and time set on the unit is not correct. ]Set date and time correctly. ( pg. 88)
●The channel position does not correspond to that in the receiving area.
]Set the correct channel position for the receiving broadcast. ( pg. 85)
The VIDEO Plus+ system does not
●The unit’s channel positions have been set incorrectly.
]Refer to “VIDEO Plus+ System Setup” ( pg. 83) and reperform the procedure.
Page 92Wednesday, 31 August 2005 19:58 |