JVC DR-MV5BEK, DR-MV5SEK Preset Download, Cable  pg , the unit will automatically perform Preset

Filename [MV5SEK_05Name.fm]
MV5SEK_00.book Page 18 Wednesday, August 31, 2005 7:58 PM	Masterpage:Left+

18 EN INITIAL SETTINGS

	Preset Download	If you have connected the unit to your TV via a 21-pin SCART
		cable ( pg. 15), the unit will automatically perform Preset
		Download instead of the Auto Set Up in step 2 on page 17. After
Auto Channel Set By Downloading From TV/Auto
		downloading, the unit sets the clock and Guide Program numbers
Clock Set/Auto Guide Program Number Set		automatically.
		● Slide the TV/DVD switch to DVD.

ATTENTION:

You can use this function only with a TV offering T-V Link, etc.* Be sure to use a fully-wired 21-pin SCART cable.

* Compatible with TVs offering T-V Link, EasyLink, Megalogic,

SMARTLINK, Q-Link or DATA LOGIC via a fully-wired 21-pin SCART

cable. The degree of compatibility and available functions may differ by

1 Press 1 to turn on the unit. The AUTO SET/T-V LINK display appears on the TV screen.

2Press rt to select “T-V LINK” and press ENTER. The T-V LINK screen will appear, and the unit automatically performs Auto Channel Set.

system.

VHS

DVD

●When Auto Channel Set is completed, “PLEASE WAIT” will be displayed for about 90 seconds, since channel data is exchanged between the DVD deck and the VHS deck. No operation will be done during this time.

ATTENTION:

Preset positions on the front display panel increase from “PR 1”; do NOT press any button on the unit or remote control until the front display panel shows clock time, “PR 1” or “– –:– –” as illustrated on page 19.

INITIAL SET UP

INITIAL SET UP / CHANNEL SET

AUTO SET

T-V LINK

SET UP	OK	SELECT WITH [CURSORS]
EXIT	SELECT	THEN PRESS [ENTER]

INITIAL SET UP

INITIAL SET UP / CHANNEL SET

AUTO SET

T-V LINK

PLEASE WAIT...

ENTER

SET UP

NOTES:	SET UP	OK	SELECT WITH [CURSORS]
● For details, refer to the instruction	EXIT	SELECT	THEN PRESS [ENTER]
manual of your TV.

●In the area where no TV station transmits a PDC (Programme Delivery Control) signal, the unit can perform neither Auto Clock Set nor Auto Guide Program Number Set.

●If there is a power cut, or if you press 1 or SET UP while downloading or set up is in progress, it will be interrupted; be sure to turn off the unit power once and try again from the beginning.

●Auto Clock Set may not function properly depending on the reception condition.

●On this unit, the characters available for station names (ID) are A–Z, 0–9, –, f, + and I (space). Some names of downloaded stations may differ from those of your TV. ( pg. 87)

After “Preset Download” is completed, perform “Monitor Set (DVD Deck Only)” on page 21.

Page 18

Wednesday, 31 August 2005 19:58