JVC DR-MV5BEK, DR-MV5SEK manual Enter REC Mode

Filename [MV5SEK_08Basic TimerDub.fm]
MV5SEK_00.book Page 40 Wednesday, August 31, 2005 7:58 PM					Masterpage:Left+
40 EN EDITING
Manual Dubbing (From DVD To VHS)					1 For DVD deck
					Load a disc you want to dub.
Dubbing A Part Of A Disc					For VHS deck
					Load a cassette with the record safety tab intact.
You can dub the selected scenes on a DVD disc to a tape, starting					2 Press }DVD to select the dubbing direction.
and stopping wherever you wish.					● “}” lights up on the unit.
					3 Prepare the DVD deck for dubbing.
● Turn on the unit.					A Press VHS/DVD on the unit repeatedly or DVD on the remote
● Turn on the TV and select the AV mode.					control so that the DVD lamp lights up on the unit.
● Slide the TV/DVD switch to DVD.					B Locate the point from where you want to start dubbing, then
● Make sure that both the DVD deck and the VHS deck are in the					pause playback.
stop mode.					4 Prepare the VHS deck for dubbing.
● Set “SUPERIMPOSE” to “OFF”. ( pg. 79)
					A Press VHS/DVD on the unit repeatedly or VHS on the remote
					control so that the VHS lamp lights up on the unit.
					B Press REC MODE repeatedly to set the recording mode.
					C Press and hold 9, then press 7 so that the VHS deck enters
					the Record Pause mode.
STANDBY/ON	VHS	DVD		REC	5 Press and hold DUBBING for more than 2 seconds to start the
			VHS DUBBING	DVD	dubbing.
			VHS/DVD	PR
S-VIDEO	VIDEO AUDIO
				DV IN	6 Press 8 to stop recording on the VHS deck.
					● Both the VHS deck and the DVD deck are stopped.
		VHS/DVD	DUBBING	DVD	● After dubbing is completed, press }DVD so that “}” lights off. If it is
					not done, recording on the VHS deck is not possible.

VHS

DVD

PR +/–

ENTER

REC MODE

PROGRESSIVE

SCAN

NOTES:

●It is not possible to start dubbing if the unit retains a memory of the resume points. Press 8 twice to clear the resume points.

●There may be a discrepancy of several seconds between where you intend dubbing to start, and where it actually starts.

●The superimposed indication during the operation or dubbing is not recorded.

●When the end of the tape is reached during dubbing, dubbing is done and “[” indicator on the front panel blinks. When pressing x (EJECT) to eject the tape, “[” indicator on the front panel stops blinking.

●When the progressive mode is set, “}” does not light up on the unit.

Press PROGRESSIVE SCAN so that video output indicator () lights off on the front display panel.

●It is not possible to perform other operations like Live Memory Playback. Check the recorded programme on the disc after dubbing.

Page 40Wednesday, 31 August 2005 19:58