JVC DR-MV5SEK, DR-MV5BEK manual Dubbing An Entire Disc, VHS/DVD Dubbing, REC Mode Progressive Scan

Filename [MV5SEK_08Basic TimerDub.fm]
MV5SEK_00.book Page 39 Wednesday, August 31, 2005 7:58 PM	Masterpage:Right+

		EDITING EN 39
	Disc Dubbing (From DVD To VHS)	1 For DVD deck
		Load a disc you want to dub.
		For VHS deck
Dubbing An Entire Disc
		Load a cassette with the record safety tab intact.
		2 Press VHS/DVD on the unit repeatedly or VHS on the remote
You can easily use this unit for dubbing without connecting any
other equipment.		control so that the VHS lamp lights up on the unit.

					3 Press REC MODE repeatedly to set the recording mode.
● Turn on the unit.					4 Press }DVD to select the dubbing direction.
● Turn on the TV and select the AV mode.
					● “}” lights up on the unit.
● Slide the TV/DVD switch to DVD.
					5 Press and hold DUBBING for more than 2 seconds to start the
● Make sure that both the DVD deck and the VHS deck are in the
stop mode.					dubbing.
● Set “SUPERIMPOSE” to “OFF”. ( pg. 79)					● If the tape has not been rewound, the VHS deck rewinds the tape
					automatically. When the VHS deck has finished rewinding, dubbing
				}DVD	begins automatically.
					● After dubbing is completed, the VHS deck rewinds the tape
					automatically and the unit shuts off.
					● To stop dubbing, press 8.
STANDBY/ON		VHS	DVD	REC	NOTES:
			VHS	DUBBING DVD	● When you turn on the unit next time, press }DVD so that “}” lights
			VHS/DVD	PR
S-VIDEO	VIDEO	AUDIO			off before performing any operations. If it is not done, recording on
				DV IN
					the VHS deck is not possible.
					● It is not possible to start dubbing if the unit retains a memory of the
			VHS/DVD DUBBING		resume points. Press 8 twice to clear the resume points.
					● There may be a discrepancy of several seconds between where you
					intend dubbing to start, and where it actually starts.
					● The superimposed indication during the operation or dubbing is not
					recorded.
					● When the end of the tape is reached during dubbing, dubbing is done
		VHS			and “[” indicator on the front panel blinks. When pressing x
			DVD		(EJECT) to eject the tape, “[” indicator on the front panel stops
					blinking.
					● When the progressive mode is set, “}” does not light up on the unit.
					Press PROGRESSIVE SCAN so that video output indicator (	)
					lights off on the front display panel.
					● It may be impossible to dub a DVD-R or DVD-RW (Video mode) disc
					recorded on the devices from other manufacturers or on a PC. In
					such case, perform “Manual Dubbing (From DVD To VHS)”
					( pg. 40).
					● It is not possible to perform other operations like Live Memory
					Playback. Check the recorded programme on the disc after dubbing.
					● If “]” lights up on the unit and you play back a DVD VIDEO disc, the
					images dubbed to the VHS deck may not be output to the TV
					properly.

REC MODE

PROGRESSIVE

SCAN

Page 39Wednesday, 31 August 2005 19:58