JVC DR-MV5BEK, DR-MV5SEK manual Scan Mode Set, OFF You cannot use the resume function

Filename [MV5SEK_13Subsidiary.fm]
MV5SEK_00.book Page 80 Wednesday, August 31, 2005 7:58 PM	Masterpage:Left+

80 EN SUBSIDIARY SETTINGS

OTHERS

8 RESUME — OFF / ON / DISC RESUME
When this function is set to “ON” or “DISC RESUME”, you can use
the resume function. ( pg. 48)	VHS
OFF: You cannot use the resume function.		DVD
ON: You can start playback from the resume point of the placed
disc.

DISC RESUME: The unit retains a memory of the resume points of the last 30 discs played back, even though they have been ejected.

NOTE:

“DISC RESUME” setting works on DVD VIDEO, VCD and already finalised DVD-R/DVD-RW (video mode) discs. For other types of discs, the function under “ON” setting will be applied even if “RESUME” is set to “DISC RESUME”.

8 AUTO POWER OFF — OFF / 3H

When this function is set to “3H”, the unit is turned off automatically if no operation is done with 3 hours.

Scan Mode Set

If you connect the unit and TV with Component Video Connection ( pg. 15), you can select the scan mode from two modes: Interlaced scan mode which is used in the conventional TV system, and Progressive scan mode which enables reproduction of higher-quality images.

8Interlaced scan

PROGRESSIVE SCAN

In the conventional video system, a picture is shown on the display monitor in two halves. The Interlaced scan system places lines of the second half of the picture in-between lines of the first half of the picture.

8Progressive scan

Progressive scan displays all the horizontal lines of a picture at one time, as a single frame. This system can convert the interlaced video from DVD into progressive format for connection to a progressive display. It dramatically increases the vertical resolution.

ATTENTION:

●Your TV needs to be compatible with Progressive.

●Make sure that there is no disc in the unit.

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/DVD switch to DVD.

1 Press DVD so that the DVD lamp lights up on the unit. 2 Press PROGRESSIVE SCAN for 3 or more seconds.

●Video output indicator () lights on the front display panel if Progressive scan mode has been established. ( pg. 14)

●Each press of PROGRESSIVE SCAN for 3 or more seconds switches the scan mode.

NOTES:

●When the progressive mode is set, be sure to set “L-1 OUTPUT” to “COMPONENT”. ( pg. 44) Progressive scan is output only from [COMPONENT VIDEO OUT] connector.

●Interlaced scan mode is the setting at your purchase.

●Interlaced scan mode might be suitable depending on video material.

●Scan mode cannot be set while menu screen is displayed.

●When the Progressive scan mode is engaged, no video signal is output from [L-1 IN/OUT] connector.

Watch the images on VHS deck in the Progressive scan mode via component video

1Set the Progressive-compatible TV to the component input mode.

2Press DVD so that the DVD lamp lights up on the unit.

3Press PROGRESSIVE SCAN for 3 or more seconds.

●The video output indicator lights up on the front display panel.

4 Press VHS so that the VHS lamp lights up on the unit, then press PROGRESSIVE SCAN.

●“]” lights up on the unit.

NOTES:

●Be sure to engage the DVD deck in stop mode.

●During still picture in VHS Progressive Scan mode, the images may jitter, but this is not a malfunction.

Page 80Wednesday, 31 August 2005 19:58