JVC DR-MV5SEK, DR-MV5BEK manual Advanced Recording VHS, Elapsed Recording Time Indication

Filename [MV5SEK_09Advanced Operation.fm]
MV5SEK_00.book Page 63 Wednesday, August 31, 2005 7:58 PM	Masterpage:Right+

		ADVANCED RECORDING EN 63
	Advanced Recording (VHS)
		To prevent accidental recording on
		Accidental erasure prevention
		a recorded cassette, remove its
		safety tab. To record on it later,
● Turn on the unit.
		cover the hole with adhesive tape.
● Turn on the TV and select the AV mode.

●Slide the TV/DVD switch to DVD.

●Press VHS so that the VHS lamp lights up on the unit.

							Record safety tab
							Watch Another Programme While Recording On The Unit
							While recording is going on, you can watch another programme on
STANDBY/ON		VHS	DVD			REC	the TV by using the TV’s tuner.
S-VIDEO	VIDEO	AUDIO	VHS/DVD		PR
			VHS	DUBBING	DVD		NOTE:
					DV IN

VHS

0000

TV/VIDEO

PR +/–

It is required that the remote control is set to be able to operate the TV in advance. ( pg. 75)

1 During recording, press TV/VIDEO to switch the TV’s input mode so that the programme selected on the TV appears.

2Slide the TV/DVD switch to TV.

3Press PR +/– repeatedly to select the desired channel.

NOTE:

If a decoder is connected to the unit ( pg. 76), you can select a scrambled channel as well as other normal channels.

Instant Timer Recording (ITR)

This easy method lets you record for from 30 minutes to 6 hours (selectable in 30-minutes interval), and shuts the unit off after recording is finished.

1 Press 7 on the unit to start recording.

2 Press 7 again to engage the ITR mode.

●On the front display panel, “0:30” appears.

3 If you want to record for more than 30 minutes, press 7 to extend the time. Each press extends recording time by 30 minutes.

NOTES:

DISPLAY

●You can only perform ITR using the 7 button on the unit.

●During Instant Timer Recording, any other timer programmed recording won’t start even if their start time has come. In such a case, the timer programmed recording starts (if the end time of the timer programmed recording is set after the end of Instant Timer Recording) after the Instant Timer Recording finishes.

Elapsed Recording Time Indication

1 Press DISPLAY until a counter reading appears on the front display panel.

2 Press 0000 to reset the counter before starting recording or playback.

● The counter is reset to “0:00:00” and shows the exact elapsed time as the tape runs. You can check the exact time of a recording or playback.

Page 63Wednesday, 31 August 2005 19:58