LG Electronics setup guide Configuration Options via Command Line, Access the HCS6300 Main Menu

Configuration Options via Command Line

Caution: Do NOT initiate simultaneous menu sessions to run commands. Doing so will interfere with active processes and may corrupt the system configuration and/or cause the HCS6300 card to cease normal operation.

Access the HCS6300 Main Menu

Note: The HCS6300 must be connected to an IP network for Telnet access. For direct access to the HCS6300 Service Port, use the FTDI TTL-USB cable (P/N TTL-232R-5V-AJ). See also “Network and Communication Setup” on page 16 for further information.

1.Establish communication with the HCS6300 using Telnet or via a direct connection to the HCS6300 Service Port.

2.Once communication is established, press Enter to refresh the menu display in the terminal. You now have access to the HCS6300 configuration Main Menu (see example below).

3.At the [Main] Command > prompt, type the desired menu command and press Enter.

Note: You can always press Enter at the [Main] Command > prompt to display the HCS6300 Main Menu. Main Menu options may vary from the example shown, depending on the HCS6300 firmware version.

The following sections describe the configuration commands.

Example: HCS6300 Main Menu

------------------------------------------

Main Menu		(Copyright 2012 - LGE USA)
------------------------------------------
info	System Information
rf	Set RF Channels
mrf	Print RF Channels Map
list	List Cards
card	Card Menu
xrst	External Card Reset
setip	Set Up IP Address
pi	Install PI Key On All Cards
pr	Reload PI Key on All Cards
upd	Update Firmware
bits	Read MUX Bitrates
rawbits	Read Bitrates at Backplane Connector
crosspt	Configure Card Number to Channel Assignment
rstpwd	Reset Password (for Reload PI Key on Web UI)

[Main] Command >

206-4122 31