Configuration Options via Command Line (Cont.)
(Continued from previous page)
1.RF
2.RF
3.RF
4.RF
5.RF
6.RF
7.RF
8.RF
Do you wish to change the mapping of physical slots to
RF channels (y/n)?
3.To change the RF channel mapping, type y and press Enter.
Note: Type n and press Enter to return to the Main Menu prompt without changing the channel mapping.
4.At the Enter the mux input number [1 - 8] > prompt, type the line number for the channel you wish to reassign. Then, press Enter.
5.At the Enter the slot number [1 - 12] > prompt, type the slot number of the transcoder card you wish to assign to the selected channel. Then, press Enter.
The system confirms the new assignment:
Set Cross point switch... OK!
and then redisplays the channel assignments along with the Main Menu prompt.
6.Repeat steps 2 to 5 to remap additional channels.
Reset Password for Reload PI Key GUI Option
Users who wish to reload a selected transcoder’s Pro:Idiom key from the GUI require a password in order to do so. This option enables you to reset the Pro:Idiom password to its default value (“service”).
Note: Users also have the ability to set a new password during the process of reloading the Pro:Idiom key from the GUI (see “Change the [Reload Pro:Idiom Key] Password” on page 23).
1.Access the HCS6300 Main Menu as described on page 31.
2.At the [Main] Command > prompt, type rstpwd and press Enter.
3.At the Reset password (y/n)? prompt for confirmation, either:
•Type y and press Enter to reset the default password immediately. The system confirms success (Password reset ok) and then redisplays the Main Menu prompt.
•Type n and press Enter to abort the password reset. The system displays confirmation (Password reset. Aborted!) and then redisplays the Main Menu prompt.
39 |