LG Electronics HCS6300 setup guide Transcoder Menu Commands, Caset

Configuration Options via Command Line (Cont.)

Transcoder Menu Commands

The following subsections describe how to access and use the Transcoder Menu commands.

Note: Refer to the Installation & Setup Guide for the applicable transcoder cards for further information on transcoder configuration options.

Access the Transcoder Menu

1.Access the HCS6300 Main Menu as described on page 31.

2.At the [Main] Command > prompt, type card and press Enter.

3.At the Enter card number (1-12) > prompt, type the chassis slot number of the transcoder card for which you wish to access configuration options. Then, press Enter.

The system identifies the card type and then displays a command prompt for the card menu, for example:

Card #1 is: HCS7710 [HCS7710 (1)] Command >

4.At the Command > prompt, either:

•Press Enter to display the card menu (see example below).

•Type the desired command and press Enter.

Note: You can always press Enter at the Command > prompt to display the Transcoder Menu.

Example: Transcoder Menu

------------

HCS7710 Menu

------------

hwid	Read Hardware ID
ver	Read Software Versions
caget	Read Content Advisory Messages Setting *
caset	Enable/Disable Content Advisory Messages *
bits	Read MUX Bitrates
pi	Install PI Key
pr	Reload PI Key
cksum	Read PI Key Checksum
stb	Satellite Receiver Menu
upd	Update Firmware
irst	Internal Reset
ret	Return to Main Menu

[HCS7710 (1)] Command >

*These commands are applicable to HCS7700 and HCS7710 cards only. Refer to the LG Service Bulletin on Content Advisory configuration options for further information.

40 206-4122