Epson DH200 Display, Sequential Setup, Press Enter to save your changes and exit

Using the Main Menu

DISPLAY

Use the Display menu to configure the OSD and Auto Sequence settings.

Figure 12.0 Display menu

To change display settings:

1.Select the DISPLAY SETUP tab, and configure the following:

•STATUS BAR: Select to Show or Hide the status bar on the OSD.

•CAMERA: Select to show the CAMERA NO. or the CAMERA TITLE or both.

•BORDER LINE: Set the color for the borders

of the OSD: WHITE, BLACK, DARK GREY, or

GREY

•BACKGROUND: Set the background color for disconnected cameras on the main display: GRAY, WHITE, BLUE, or DARK GREY

•SPLIT MODE: Set up to four split-screen display modes

•QUICKSETUP:SelectON/OFF toenable/disable the quick setup menu

2.Press ENTER to save your changes and exit.

Sequential Setup

Configure Sequential Setup (Auto Sequence) settings.

Figure 12.1 Auto Sequence setup

To configure Sequential Setup settings:

1.Select the SEQUENTIAL SETUP tab and configure the following:

•DWELL TIME: Set from 1~30 seconds.

•SEQ.MODE:Setthedisplaymode,fromsingle channel full-screen to 8-channel split-screen

NOTE: You must select one of these display modes to enable Auto Sequence mode. If none of these modes are selected, Auto Sequence will not begin.

•FULL SCREEN: Select channels for full-screen display. If selected, these channels will appear in full-screen during Auto Sequence mode

2.Press the ENTER button to save your settings and enable Auto Sequence. Auto Sequence will immediately begin.

3.Press the DISPLAY button to stop Auto Sequence.

Auto Sequence with Front Panel and Remote Control

Once you have configured the Auto Sequence settings in the Display menu, you can use the remote control to turn Auto Sequence on/off.

To enable/disable Auto Sequence:

1.Press and hold on the front panel or remote control for 2 seconds.

2.To exit press . The main screen will return to a quad display.

22