Remote Setup
RECORD
Figure 35.0 Record options
To configure continuous recording options:
1.Select a camera.
NOTE: Number of displayed cameras depends on model number of your system.
2.For each camera configure the following:
•USE: Select ON/OFF. If OFF, the selected camera(s) will not record.
NOTE: The system will automatically reset if you enable/disable any cameras.
•QUALITY: Select LOW, MIDDLE, HIGH, SUPER, and ULTRA.
•RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
•AUDIO: Select ON/OFF. Audio capable cameras or microphones are required for audio recording.
•MOTION: Select ON/OFF. If Motion is set to ON, the system will only record from the selected camera when motion is detected.
NOTE: Motion Grid and sensitivity must be configured in the Motion menu. See “MOTION” on page 61.
3.Click APPLY and then OK to save your changes and close the window.
ALARM
Figure 36.0 Alarm options
To configure alarm settings:
1.Under RECORD SETUP, configure the following:
•USE: Select ON/OFF. If OFF, the selected camera(s) will not record.
•QUALITY: Select LOW, MIDDLE, HIGH, SUPER, and ULTRA.
•RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
•AUDIO: Select ON/OFF. The number of audio input channels varies by model.
•INPUT: Select N.O/N.C.
2.Under ALARM SETUP, configure the following:
•RECORD TIME: Set from 10~300 seconds (in increments of 10 seconds).
•RECORD CAMERA: Select ALL or 1:1. If you select ALL, the system will record on all channels; if you select 1:1, the system will only record for the designated channel
•ALARM BUZZER: Select ON/OFF. If ON, the system will sound a beep when the external alarm is triggered
3.ALARM OUT1: Set the type of Alarm Out video (external monitor required, not included). Select SYSTEM, VIDEO LOSS, MOTION, ALL ALARM, or ALARM IN1~8, and then select ON/
OFF
4.Click APPLY and then OK to save your settings and close the window.
62