Epson DH200 Schedule, Under Alarm SETUP, configure the following, To set a recording schedule

Page 35

Using the Main Menu

2.Under ALARM SETUP, configure the following:

•RECORD TIME: Set from 10~300 seconds (in increments of 10 seconds).

•RECORD CAMERA: Select ALL or 1:1. If you select ALL, the system will record on all channels; if you select 1:1, the system will only record for the designated channel

•ALARM BUZZER: Select ON/OFF. If ON, the system will sound a beep when the external alarm is triggered

•ALARM OUT1: Set the type of Alarm Out video (external monitor required, not included). Select SYSTEM, VIDEO LOSS, MOTION, ALL ALARM, or ALARM IN1~8, and then select ON/OFF.

Figure 16.1 Alarm Setup

3.Press ENTER to save your settings. Press CANCEL/ESC to close remaining menu windows.

NOTE:Alarmrecordingwilltakepriorityover continuous recording, even if a camera is disabled in standard recording parameters.

TIP!

If an alarm is triggered on

the system, press the Cancel/ESC button to cancel the buzzer (if enabled). Cancelling the buzzer will not stop recording.

SCHEDULE

Set four recording modes in a daily or weekly schedule.

NOTE: Daily has priority over a Weekly schedule.

Figure 17.0 Alarm Setup

To set a recording schedule:

1.Press WX to select MODE1 (red), MODE2 (orange), MODE3 (green), or MODE4 (blue).

2.With a mode selected, configure the following:

•USE: Select ON/OFF. If OFF, the selected camera(s) will not record.

•QUALITY: Select LOW, MIDDLE, HIGH, SUPER, and ULTRA.

•RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.

•AUDIO: Select ON/OFF. Audio channels vary by model.

•MOTION: Select ON/OFF. Motion Grid and sensitivity must be configured in the Motion menu. See “MOTION” on page 23.

3.Select the CHART tab and select ALL, SUN, MON, TUE, WED, THU, FRI, or SAT, and press the ENTER button or +/-. The Schedule sub-menu opens.

4.Enter BEGIN and END times, and select the MODE for ten time slots.

25

Image 35

Contents Copyright 2009 Digimerge Technology Inc Digimerge TouchExpose this Unit to Rain or Moisture Important Safeguards InstallationGeneral Precautions ServiceFCC Class a Notice Features Table of Contents Backup Appendix a System Specifications Appendix C Setting Up Ddns Service System comes with the following components Getting StartedBasic Setup Front Panel Front Panel cont’d Rear Panel Navigation/Menu Remote ControlTouch Panel Tips and Tricks Mouse ControlMouse Tips Using Quick Setup Using the SystemQuick Setup Enabling/Disabling Quick Setup PasswordUsing Quick Setup cont’d System shows the following for all display views On-Screen DisplayMany of the system’s features using only a USB mouse Using the Virtual RemoteRight-click anywhere on the screen to open the Virtual Remote. The Virtual Remote gives you quick access toPlayback Using the Virtual KeyboardTime menu Setting the TimeRepositioning Channels Multi-Screen DisplayZoom Sequential Setup Auto SequenceEvent Recording RecordingContinuous Recording Motion assigned to channel 4 4CH model shown MotionVideo Loss AlarmSchedule Recording Recording AudioPlayback View recorded video on the system through playback modeTime Search menu SearchSystem Main Menu Using the Main MenuPress Enter to save your changes and exit Sequential SetupConfigure Sequential Setup Auto Sequence settings DisplayMotion CameraRecord AlarmSet four recording modes in a daily or weekly schedule Under Alarm SETUP, configure the followingWith a mode selected, configure the following ScheduleOvernight Recording Stopping Scheduled RecordingNetwork Network menu IP setupTo configure bandwidth settings Configure Digimerge Ddns settingsConfigure additional network settings System Configure System settingsPassword is set to OFF Only the Admin can configure user authorities on the systemDisk Press CANCEL/ESC to close windows USB flash drive onlyUpdateinfo USB Flash Drive BackupSystem will prompt, Status no File External USB HDDUSB CD/DVD-RW Backup menu Time Search and BackupBackup video player file Viewing Backup VideoMcdPlayer main window image simulated Using MCD PlayerSystem Requirements DVR NetviewTo install DVR NetView Installing DVR NetviewDVR NetView main screen Using DVR NetviewTo delete a DVR Select a DVR from the list frame Adding a DVREditing a DVR Deleting a DVRDVR NetView main screen DVR NetView Main ScreenClick Apply and then click OK to close the Setup menu DVR NetView SetupUnder the Sound tab, configure the following DVR Indicators Live ModeOnscreen Display Camera IndicatorsDisplay Views Changing ChannelsRight-click the DVR to view the sub-menu Click anywhere on DVR NetView to close the sub-menuSub-Menu Health Report HealthClearing Health Status Health Report Color Codes PTZ control PTZRemote Recording RecordingPlayback Playback mode defaultControl playback with the following buttons Remote PlaybackPlayback Controls Download window Remote DownloadFile Naming Conventions Local PlaybackOpen Playback Mode and click Search Playing Backup FilesCreating a Virtual DVR Virtual DVRTo delete a Virtual DVR Select a DVR from the list frame Editing a Virtual DVRDeleting a Virtual DVR Virtual DVR PropertiesVirtual DVR Indicator Configuring a Virtual DVRDeleting Cameras from a Virtual DVR Drag the camera back to the DVR icon in the DVR IndicatorRemote Setup menu Remote SetupDisplay options Sequential Setup Auto SequenceCameramotion To configure Camera optionsTo configure Motion options Record options To configure continuous recording optionsMotion Select ON/OFF Dhcp NetworkemailDdns options DdnssystemTimecontrol 16 x 1.0Vp-p, CVBS, 75ohms, BNC Appendix a System SpecificationsDVR DVR cont’d DimensionsNot Included Appendix B Setting UP Remote ViewingNetwork Setup / Remote Access Overview What Do I Need?Finding Your External IP Address How Do I Find My IP and MAC addresses?7000 How Do I Enable Port Forwarding?Create a Ddns account Appendix C Setting UP Ddns ServiceUsername Domain name Password How Do I Enable Ddns On My System? Connecting a PTZ camera not included Appendix D Connecting PTZ CamerasUsing a PTZ Camera Button Compatible PTZ Cameras Appendix E Connecting Additional External Monitors Appendix F Connecting Motion / Alarm Devices Appendix G Full Connectivity Diagram Removing the Hard Drive Remove the hard drive from the housingAppendix H Replacing the Hard Drive Place the HDD on the rubber mounting feet Replacing the Hard DriveHDD format Formatting the Hard DriveLine OUT / Amplified Speakers Appendix I Using LISTEN-IN AudioAVI Converter Appendix J Converting Video Files to AVIFile playback in Windows Media Player image simulated Playing AVI FilesAppendix M Remote Viewing Using Internet Explorer Using Live Viewer CMS Log List Appendix N DVR Properties and LOG FilesDVR Properties Advanced Search DVR Log ListError Possible Causes Solutions TroubleshootingTroubleshooting cont’d Limited Warranty Canada Need HELP?