APPENDIX F: CONNECTING MOTION / ALARM DEVICES
You can enable motion detection and alarm control from the Main Menu. You can also connect additional motion sensor devices to the system (i.e. motion sensors, door/window sensors). Use a motion detector or sensor to send a signal to the system to begin camera viewing and recording on the matching camera channel (when enabled in the Menu).
To connect an external alarm sensor to the system:
1.Connect the Signal Cable to the desired Channel number + port in the alarm block.
2.Connect the Ground cable to the Ground port (G) in the alarm block.
3.Open the MAIN MENU and select ALARM.
4.Select the corresponding alarm channel and select INPUT.
5.Select N.C. (Normally closed) or N.O. (normally open) depending on your alarm/sensor setup. Make sure the channel is set to ON.
6.Press the ENTER button to save your settings.
DVR
ALARM or SENSOR
(Not Included)
80