Sony TC-WE405, TC-WR661 manual Dubbing only specific portions, 10EN, During high-speed dubbing

Advanced Recording Operations

zDuring high-speed dubbing

Only p is operative.

zYou don‘t have to adjust the recording level or select the Dolby NR system during dubbing

Dubbing is automatically performed with the same recording level and Dolby NR system as the original in deck A. If, however, you want to monitor the sound during normal-speed dubbing, set DOLBY NR to match the tape in deck A (see page 5).

Note

If a TV set is placed near the tape deck, noise may occur during high-speed dubbing. In that case, turn the television set off or move it away from the tape deck.

Inserting a Blank Space During Recording (Record Muting)

You can insert a blank space of 4 seconds between each track or erase unwanted portions on a tape.

		￿	REC MUTE R á
		PAUSE P
					AUTO
			DIRECTION	DOLBY NR		REC LEVEL
			D a RELAY OFF		B C	4	5 6
					3		7
			SYNCHRO DUBBING A→B		2		8
			HIGH/NORMAL	FADER	ARL
			START(DECK B P)		1		9
	DECK A	DECK B	PAUSE	REC MUTE	REC	0	10
	COUNTER RESET		P	R	r
	0	)	0	)			PHONES
POWER	p	» á	p	»	á
		¤	¤

Dubbing only specific portions

You can do this only during the normal-speed dubbing.

1Press p on deck A at the portion you want to skip.

Deck B changes to recording pause.

2Locate the point you want to resume recording on deck A, then stop the tape.

3Press PAUSE P to resume dubbing.

10EN

1Start recording.

2Press REC MUTE R where you want to insert a blank space.

“REC” flashes in the display and a blank is recorded on the tape.

After 4 seconds, P lights up and the tape deck changes to recording pause.

3Press PAUSE P or á to resume recording.

zIf you want to insert a blank space longer than 4 seconds

Hold down REC MUTE R as long as you want. After 4 seconds, “REC” flashes faster.

When you release REC MUTE R, P lights up and the tape deck changes to recording pause.

Press PAUSE P or á to resume recording.

3-810-312-31(1)