Sony TC-WR661, TC-WE405 manual Playing a Tape, To play back Set to, Press

	Basic Operations		Basic Operations
	Playing a Tape
2		4	3

								AUTO
				DIRECTION	DOLBY NR			REC LEVEL
				D a RELAY OFF		B	C	4	5
									6
								3	7
				SYNCHRO DUBBING A→B				2	8
				HIGH/NORMAL	FADER	ARL
				START(DECK B P)				1	9
	DECK A		DECK B	PAUSE	REC MUTE	REC		0	10
	COUNTER RESET			P	R	r
	0		)	0	)				PHONES
POWER	p	»	á	p	»	á
			¤	¤

•See page 4 for hookup information.

•You can use either deck for playback.

zTo locate the beginning of a tape and start playback automatically (Auto Play)

Press 0 while holding down á. For the reverse side, press ) while holding down ».

zTo play a tape recorded with the Dolby NR* system

Set DOLBY NR to the same position that the tape was recorded in—B or C.

zWhat is the Dolby NR system?

The Dolby NR (noise reduction) system eliminates tape hiss noise by boosting low-level signals in the high- frequency range during recording, then lowering them during playback. Type C provides greater noise reduction than type B.

zYou can connect the headphones to PHONES (TC-WE405 only)

*Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation.

“DOLBY“ and the double-D symbol aare trademarks of Dolby Laboratories Licensing Corporation.

1	Turn on the amplifier and select the tape deck position.
2	Press POWER, and then press ¤
	and insert a cassette.

With the side you want to play facing you

3 Set DIRECTION.

To play back	Set to
One side only	A
Both sides continuously*	a
Both decks in succession*	RELAY

* The deck automatically stops after playing back five times.

4 Press á.

The deck starts playing. Adjust the volume on the amplifier.

To	Press
Stop playing	p
Start playback from the reverse side	»
Pause (deck B only)	PAUSE P. Press the button again to
	resume play.
Fast-forward or rewind	)or 0 when the deck is stopped
Take out the cassette	¤after stopping playing

5EN

Basic Operations

3-810-312-31(1)