Sharp LC-46LB700X operation manual To cancel Repeat Playback, Switching the Audio

Disc Playback

Partial Repeat Playback (Repeat Playback of a Specified Part)

DVD-VIDEO DVD-R DVD-RW

AUDIO CD

NOTE

•Some operations in the following playback function cannot be performed depending on the specifi cations of the disc.

1 Press DISC MENU during playback.

• The DISC MENU control screen is displayed.

2Press a/b to select “”, and then press

ENTER.

3Press a/b to select “On”, and then press

ENTER.

4Press c/d to select “Scene Selection”, and then press ENTER.

• “Set Start Point” displays.

To cancel Repeat Playback

1Press a/b to select “” while the DISC MENU control screen is displayed.

2Press c/d to select “Off”, and then press

ENTER.

NOTE

•Press U, the Repeat Playback is cancelled and the next chapter is played back.

•Press T once, the Repeat Playback is cancelled and the TV returns to the start of current chapter (track).

•If you press T again (within about 5 seconds), the TV will skip to the beginning of the previous chapter (track).

•For Partial Repeat Playback, set the start and end points within the same title.

•Repeat Playback may be forbidden depending on the disc.

•Partial Repeat Playback may not work in multi-angle scenes.

•If you press DISPLAY, you can confi rm the Repeat Playback status.

Switching the Audio

You can change the audio track using MPX.

• The displayed information varies depending on the disc.

BD-VIDEO DVD-VIDEO

If multiple audio is recorded, you can switch the audio each time you press MPX.

The newly selected audio track will be displayed.

DVD-RW DVD-R

When a recorded broadcast with stereo or monaural audio is played back:

“Stereo” is displayed. (Audio cannot be switched.)

Playback Title

Playback Chapter

Scene Selection

Set Start Point

5Press ENTER at the scene where you want to set the start point.

• “Set Start Point” displays.

6Press ENTER at the scene where you want to set the end point.

•You can press J to fast forward to the scene

where you want to set the end point. When you reach the desired scene, simply press d and then ENTER to set the end point.

62