Sharp LC-46LB700X For the Option Ethernet connection speeds, Test, then press Enter

Blu-ray disc Setup

Communication Setup (continued)

12	For the advanced setting (the setting of the
	Ethernet connection speeds), press c/d to

select “Yes” or “No”, then press ENTER.

• Normally select “No”, then press ENTER. (Go to the step 14.)

Perform advanced setup?

Yes

No

	• The Ethernet connection speeds can be set when
	you select “Yes”, then press ENTER.
13	For the Option Ethernet connection speeds,
	press c/d to select the connection speed,
	then press ENTER.
	Option
	ETHERNET Connection Speeds

Auto-Detection

10M Half Duplex

100M Half Duplex

10M Full Duplex

100M Full Duplex

			Next
	•	As automatic detection is made (factory preset
		mode), this setting is not normally necessary. If a
		situation occurs in which the Ethernet connection
		fails, etc., change the setting and confi rm if the
		Ethernet connection successfully works.
		When the connection speed is set, select “Next”,
		then press ENTER.
14	For testing the connection to the internet, after
	confi rming the settings, press c/d to select
	“Test”, then press ENTER.
	•	“Test” is available only when setting to obtain
		the IP address automatically. “Test” cannot be
		selected if the IP address has not been obtained
		automatically.
		Confirm the current setting.
		IP Address	: xxx xxx xxx xxx
		Netmask	: xxx xxx xxx xxx
		Gateway	: xxx xxx xxx xxx
		DNS Address : xxx xxx xxx xxx
		MAC Address : xx:xx:xx:xx:xx:xx
				Complete

•As a result of the test, if the internet connection fails, enter the setup values manually.

15	Press c/d to select “Complete”, then press
	ENTER.

67