JVC HR-IP820U Recording contd, Instant Timer Recording, Hi-Fi Audio Recording Level Control, Set

HI-FI REC LEVEL CONTROL

PRESET

⮕MANUAL

PRESSPRESS

(REW)(FF) MIN------⋆------MAX

PRESS (SET +/–) FOR CHOICE PRESS (MENU) TO END

HR-IP820U-EN-2 97.5.20 5:32 PM Page 24

	Recording (cont'd)
				Instant Timer Recording
				To set the VCR to shut-off automatically after recording.
				During Recording...
+		000	0	1 Press the VCR's REC button. The "ITR" indication blinks and
–			0000	"0:30" appears indicating the recording will continue for 30
	000000		000000
	000	0	000
	000		0000
	00		0
	00		00	minutes and then power will switch off.

				ITR	REC
				VIDEO SP
			REC
				2 Press REC again to extend the record time by 30-minute
				increments (up to 9 hours).
				■ This function is available only using the REC button on the
				VCR.
				■ After the off-time is set, the display returns to the
				previously displayed mode (counter, channel or clock).
1	2	3		■ You can check the time remaining before the VCR shuts off
4	5	6		by pressing REC once; the remaining time is displayed for
				5 seconds. (Pressing REC more than once will extend the
			SELECT
7	8	9		record time.)
	0

MENU

SET

REW FF

Hi-Fi Audio Recording Level Control

Your VCR allows manual adjustment of the Hi-Fi audio recording level. Although the preset audio recording level is satisfactory for normal recording, if the sound you are going to record is too loud or too low, adjust the audio recording level while referring to the VCR's audio level meters.

1 Press MENU, SET, and SELECT as many times as necessary to access the HI-FI REC LEVEL CONTROL screen. (☞ p.7)

2 Press SET to choose "MANUAL".

3 Press FF or REW to adjust the audio recording level.

■To move the on-screen's audio levels by one division of the scale, press FF or REW briefly for 5 times in succession. To move the audio levels faster, keep FF or REW presssed.

■Adjust the recording level so that the audio level meters reach from 0dB to 4dB at the maximum sound volume.

4Press MENU as many times as necessary to exit.

NOTE:

■ Noise will increase if the recording level is too low, while distortion will increase if the level is too high.

Accidental erasure prevention

■To prevent accidental recording on a recorded cassette, remove its safety tab.

To record on it later, cover the hole with adhesive tape.

Safety tab

24