JVC LPT0762-001B, HR-XVS20AA manual 84 EN, Perform Auto Channel Set, Stations your unit located

CH FRQ SYS CH FRQ SYS

01 150 BG 07 229 BG

02 165 BG 08 237 BG

03 195 BG 09 355 BG

04 205 BG 10 365 BG

05 213 BG 11 374 BG

06 221 BG 12 384 BG

84 EN SUBSIDIARY SETTINGS (cont.)

E Select the TV system.

Press rt to move the highlight bar (pointer) to the appropriate TV system (refer to the table below).

TV SYSTEM SELECT

B/G

D/K

I

[ / ] [MENU] : EXIT

Major Countries/Areas	TV System
Australia, New Zealand, Kuwait, U.A.E.,
Indonesia, Singapore, Thailand, Malaysia,	B/G
Iran, Saudi Arabia, Egypt, Morocco,
Lebanon, Iraq
China, Mongolia, Russia	D/K
Hong Kong	I

F Perform Auto Channel Set.

Press OK or e.

●The Auto Set screen appears, and remains on screen while the unit searches for receivable stations. As Auto Channel Set progresses, the “q” mark on the TV screen moves from left to right. Wait until the TV screen as shown in step G appears.

	AUTO CH SET
	PLEASE WAIT
START	FINISH

■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ – – – – – – –

IMPORTANT

●When programming the timer using the G-CODE/

SHOWVIEW system, be sure to check the desired channel is selected correctly. ( pg. 32, “G-CODE™/SHOWVIEW™ Timer Programming”) (S-VHS deck only)

●Your unit memorizes all detected stations even if reception

of some of them is poor. You can delete those stations with an unacceptable picture. ( pg. 86, “Delete A Channel”)

NOTES:

●Fine tuning is performed automatically during Auto Channel Set. If you want to perform tuning manually, refer to page 86.

●If you perform Auto Channel Set when the aerial cable is not connected properly, “SCAN COMPLETED –NO SIGNAL–” appears on the TV screen in step G. When this happens, make sure of the aerial connection and press OK; Auto Channel Set will take place again.

●If no sound accompanies the picture or the audio sounds unnatural on some channels that have been stored by Auto Set Up, the TV system setting for those channels may be incorrect.

Select the appropriate TV system for those channels.

( pg. 86, “TV System Selection — When you see the picture but the audio can’t be heard or sounds unnatural”)

G View the channel list screen.

After “SCAN COMPLETED” is displayed on the TV screen for about 5 seconds, the channel list screen looking like the one to the right appears. The

stations your unit located	[	/	]	[	] : DELETE
	[	/	]		: EDIT
appear on a channel list screen	[MENU] : EXIT

—channel position (CH),

frequency (“FRQ”) and TV system (SYS). The blueback screen and the programme currently being broadcast by the blinking station appear alternately for 8 seconds each. To view the next page, use the rt button on the remote control.

H Return to the normal screen.

Press SET UP MENU.

●Using the Confirmation screen, you can delete channels, swap channel positions and fine-tune channels already stored. Refer to page 85 – 86 for the procedures.