MUSIC SENSOR
If there is a
Press the
For example, when the ➤* button is pressed while > is displayed, playback of the next track starts.
Music sensor function may not be able to detect tracks under the following conditions:
●Blanks of less than 4 seconds between tracks
●Noisy blanks
●Long passages of
●Low overall recording levels
CONTINUOUS PLAY
I
3 h“---
After playback on one deck finishes, the tape in the other deck will start to play without interruption.
1 Insert tapes into deck 1 and deck 2.
2 Press the TAPE/DECKl/2 button to select the deck to be played back first.
3 Press the REV MODE button to select Z).
4 Press the 4> button to start playback.
Playback continues until the ■ button is pressed.
About cassette tapes
●To prevent accidental erasure, break off the plastic tabs on the cassette tape after recording with a screwdriver or other pointed tool.
Type 11tape | Tab for side A |
detection |
|
slot |
|
To record on the tape again, cover the tab openings with adhesive tape, etc. (On Type 11 tapes, take care not to cover the Type 11tape detection slot.)
●
●Take up any slack in the tape with a pencil or similar tool before use. Slack tape may break or jam inthe mechanism.
\
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape recorded with the DOLBY NR system, turn on the DOLBY N R system.
ENGL/S/+ 1 ~!