Sony CX-NMT90 manual Setting the Sleep Timer, Timer Recording, Prepare the source

Page 23

SETTING THE SLEEP TIMER

The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.

*If this step is not completed within 4 seconds, repeat from step 1.

5 Prepare the source.

To listen to a CD, load the disc to be played first on tray 1.

To listen to a tape, insert the tape into deck 1 or 2.

To listen to the radio, tune in to a station.

6 Press the POWER button to turn the unit off after adjusting the volume and tone.

O remains on the display after the power is turned off (timer standby mode),

The unit can be turned off automatically at a specified time

Use the remote control.

1 Press the SLEEP button.

When the timer-on time is reached, the unit turns on and begins play with the selected source.

●The volume level is automatically set to 16 when the power is turned off with the volume level set to 17 or more.

To check the specified time and source

Press the TIMER button. The timer-on time, the selected source name and the duration for the timer-activated period are displayed

for 4 seconds.

To cancel timer standby mode temporarily

Press the TIMER button repeatedly so that 0 or Q)REC disappears on the display.

To restore the timer standby mode, press again to display @ or @ REC.

Using the unit while the timer is set

You can use the unit normally after setting the timer,

Before turning off the power, repeat step 5 to prepare the source, and adjust the volume and tone.

EEn3

●Timer playback and timer recording will not begin unless the power is turned off,

●Connected equipment cannot be turned on and off by the built- in timer of this unit, Use an external timer,

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.

Press the TIMER button repeatedly until @)REC appears on the display, and press the II SET button within 4 seconds.

Carry out the steps of “SETTING THE TIMER from step 2 and

insert the tape to be recorded into deck 2 after step 5.

2 Within 4 seconds, press the <+ or FF t.yutton to specify the time” until the power is turned oflf.

Each time the button is pressed, the time changes betvveen 5

and 240 minutes in 5-minute steps.

m

Specified time

To check the time remaining until the power is turned off

Press the SLEEP button once. The remaining time is displayed

for 4 seconds.

To cancel the sleep timer

Press the SLEEP button twice so that “SLEEP” on the clisplay

disappears.

ENGLISH 22

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Tmi3iE AC power cord PrecautionsInstallation Electric PowerContents Owner’s record Setting UPPositioning the Speakers ConnectionsConnect the center speaker Connect the supplied antennasConnect the front speakers Connect the surround speakersTo connect other optional equipment+ Remote ControlConnecting AN Outdoor Antenna BBE System Audio AdjustmentsVolume Before OperationPress the GEQ button repeatedly until the desired Sound adjustment during recordingGraphic Equalizer DSP Surround SystemPress the TUNER/BAND button to select a band Manual TuningPreset Number Tuning Repeat steps 1Playing Discs Basic OperationsLoading Discs Random /REPEAT Play Press the Prgm button twice in stop modeProgrammed Play Playing Back a Tape Inserting TapesAbout cassette tapes Continuous PlayPress the . REC/REC Mute button to start recording Basic RecordingInserting Blank Spaces Press the Dolby NR button to turn Dolby NR on or offDubbing the Whole Tape Dubbing a Tape ManuallyTime on cassette tapes and editing time To stop recordingTo add tracks from other discs to the edit program Press the O REC/REC Mute button to start recording Programmed Edit RecordingPress the +4 or button to designate the tape length Repeat for the rest of the tracks for side aDolby To change the delay timePress the Dolby PRO Logic button to select Rear-mounted surround speakers enhance the depthAdditional Dolby PRO Logic Modes Play with Dolby PRO LogicAuto Multiplex function Microphone MixingVocal FADER/MULTIPLEX Functions Connect your microphones to the MIC 1 and MIC 2 jacksKaraoke Program Clock display flashes Setting the Clock Setting the TimerTo switch to the 24-hour standard To display the current timePress the Sleep button Setting the Sleep TimerTimer Recording Prepare the sourceLine OUT Jacks Connecting Optional EquipmentListening to External Sources VIDEO/AUX, MD JacksTroubleshooting Guide Care and MaintenanceGeneral Page Electric Shock PrecaucionesInstalacion Enerafa electricaNo Trate DE Reparar LA Unidad Usted Mismo IndiceOPERAClONES Basicas Antena exteriorCompruebe su sistema y accesorios @o@ InstalacionUbicacion DE LOS Altavoces ConexionesConecte el altavoz central Conecte Ias antenas suministradasConecte Ios altavoces delanteros Conecte Ios altavoces de sonido ambientalConexion DE UNA Antena Exterior Control RemotoSistema Bbie Control DE VolumenAntes DE LA Operacion Ajustes DE AudioPulse repetidamente el boton GEQ hasta que se visualice Ecualizador GraficoSistema DE Sonido Ambiental DSP Pulse el boton 1++ Down o 1 UP para seleccionar una emisora Sintonizacion ManualPreajuste DE Emisoras Compartimiento, pulse el boton + Introduction DE DiscosReproduction DE Discos Pulse dos veces el boton Prgm estando en el modlo de parada REPR3DUCCION ProgramadaReproduction ALEATO131A/ Repetition DE Reproduction Pulse el boton para iniciar la reproduction Operaciones BasicasInsercion DE Cintas Reproduction DE UNA CintaSistema Dolby NR Sensor MusicalAcerca de Ias cintas de casete Las cintas de 120 minutes o mas son extremadamentePulse el boton Dolby NR para activar o desactivar Dolby NR Grabacion BasicaInsercion DE Espacios SIN Grabar Inserte la cinta que vaya a grabar en la platinaGrabacion Copiado Manual DE UNA Cinta Copiado DE Toda LA CW+ITAPuke el boton Dolby NR para desactivar Dolby Nl% Pulse el boton TAPE/DECK 1/2 para seleccionar la platinaTiempo de Ias cintas de casete y tiempo de edition Para detener la grabacionPara borrar el programa de edition Pulse el bot6n O REC/REC Mute para inicialr la grabacion Grabacion CON Edicion ProgramadaDolby NR para activar o desactivar Dolby NR Pulse Ios botones 4 0 para designar la duration de la cintaPara cambiar el tiempo de retardo Ajuste DEL Equilibria DE Sonido DE LOS AltavocesPulse el boton Dolby PRO Logic para seleccionar Normal Los altavoces de sonido ambiental montados en la partePara cambiar Ios niveles de sonido durante la reprociuccion Para cancelar el modo Dolby Pro LogicReproduction CON Dolby PRO Logic Otros Modos Dolby PRO LogicPara cambiar el tiempo de retardo del eco Mezcla MicrofonicaConecte sus microfonos a Ias tomas MIC 1 y Clear Programa DE KaraokePara detener la reproduction Si parpadea la visualization del reloj Puesta EN Hora DEL RelojAjuste DEL Temporizador Para visualizer la hors actualPrepare la fuente de sonido Ajuste DEL Temporizador Para DormirGrabacion CON Temporizador Escucha DE Fuentes DE Sonido Externas Conexion DE UN Equipo OpcionalCuidados Y Mantenimiento Guia Para LA Solucion DE ProblemasSeccion de la platina EspecificacionesSistema de aitavoces SX-NA94 Tipo de caja Page ElA= Al’ DES Matieres Connexions InstallationContr61er la chalne et Ies accessoires Positionnement DES EnceintesConnecter Ie televiseur a I’appareil vid60 Ies antennes Fournies ConnecterSurround Connecter I’appareil videoConnexion D’UNEANTENNE Exterieure TelecommandeSysteme Super T-BASS Avant L’UTILISATIONReglages Audio Systeme BBESysteme Surround DSP Egaliseur GraphiqueRepeter Ies etapes 1 et Accord ManuelMemorisation DE Stations Accord SUR UNE Station MemoriseeLecture DE Disgwes Selection d’une plage avec la telecommandeOperations DE Base Mise EN Place DE DisquesLecture ALEATOIRE/REPETEE Appuyer deux fois sur la touche Prgm clans Ie mode arriMLecture Programmed Appuyer sur la touche +~ pour demarrer la lecture Pour selectionner un mode d’inversion platine 2 seulementMise EN Place DE Cassettes Lecture D’UNE CassetteSenseur DE Musique Lecture ContinueInsertion D’ESPACES Blancs Enregistrement DE BasePour arr~ter la duplication Pour arriXer la duplicationPour controler I’ordre des numeros des plages programmers Enregistrement Avec Montage ET Calcul DU TempsPour arr&er I’enregistrement Pour effacer Ie programme du montagePour changer Ie programme de chaque face Enregistrement Avec Montage ProgrammeRepeter I’etape 5 pour Ie reste des plages de Ila Face a Pour changer Ie temps de retard Reglage DE LA Balance DES Niveaux DES EnceintesRegler Ie niveau sonore des enceintes centrale et surround Les enceintes surround montees a I’arriere ameliorent laNormal ~ Phantom a 3 CH Logic Autres Modes Dolby PRO LogicPour selectionner Phantom ou 3 CH Logic Pour changer Ie temps de retard de I’echo Mixage Avec MicrophoneFonctions Vocal Fadeiwmultiplex Brancher Ies microphones aux prises MIC 1 et MICPour contr61er Ies plages reservees Programme DE KaraokePour sauter une plage en tours de lecture Source REGLAGEDEL’HORLOGE Reglage DE LA MinuteriePendant ces auatre secondes, appuyer sur une Pour ecouter un disque compact, mettre Ie disque a Iire en Enregistrement Commande PAR LA MinuterieReglage DE LA Minuteriie ’ARRET Preparer la sourceEcoute DE Sources Externes Connexion D’UN Appareil OptionnelSoinis ET Entretien EN CAS DE ProblemeSpecifications Page Nomenclature Parts IndexIndice DE LAS Partes
Top Page Image Contents