SETTING THE CLOCK
SETTING THE TIMER
1
2,4
3
1,2
/,-
Ju/1 (
1 Press the CLOCK button on the remote control, and press the II SET button within 4 seconds.
2 Press the <+ DOWN or F- UP button to designate the hour, and press the II SET button.
The hour stops flashing and the minute starts flashing.
3 Press the ++ DOWN or ➤ F UP button to designate the minute, and press the II SET button.
The minute stops flashing on the display and the clock stark from 00 seconds.
To display the current time
Press the CLOCK button on the remote control. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button on the remote control and then press the ■ button within 4 seconds.
Repeat the same procedure to restore the
[f the clock display flashes
This is caused by a power interruption. The current time needs to be reset,
If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.
6
The unit can be turned on at a specified time every day with the
Preparation
Make sure the clock is set correctly.
Use the remote control.
1 Press the TIMER button repeatedly until @ appears on the display , and press the II SET button within 4 seconds.
O is displayed, and the hour flashes
m
If you press the II SET button after 4 seconds, another operation may start.
2 Designate the hour of the
After you designate the
flashes on the display for 4 seconds.
3 Within 4 seconds, press one of the function buttons to select a source.
The selected source name flashes for 4 seconds. At this time, the selected function button does not light up.
●If this step is not completed within 4 seconds, repeat from step 1.
●If the TUNER button is pressed, the band cannot be selected in this step.
4 Within 4 seconds, select the duration for the