Operation
INSTALLING DISK MODULE
NOTE: The disk module can be installed with the disk module handle in any of its five positions and the function switch in any of its four positions. However, it is recommended that the handle be pulled out and that the function switch be in an unlocked mode. If the disk module is plugged into the docking base with its handle in Position 1, the hard disk will immediately start to spin up.
NOTE: Refer to the TranzPak 6 User Manual for details about system operations.
Although the handle does not have to be used for supporting the module during installation, it is designed as an installation aid by holding the entire weight of a loaded disk module in any position.
It allows the disk module to be held with one hand so that it can be guided into the docking base with the other hand.
With the handle extended from the disk module, grasp the handle and guide it into the docking base.
Push firmly on the disk module front panel until the disk module is fully seated.
You will hear a snap or a click that indicates the module latch locking mechanism is engaged.
The center active light (green LED) on the front panel will blink, indicating that there is power going to the disk module.
18
Document#