Z Microsystems manual Final Adjustments, Securing ZX Station in Cabinet Frame

Page 11

Install ZX Station

FINAL ADJUSTMENTS

Slide the ZX Station partially out.

Lift the ZX Station while tightening the pancakehead Phillips screws in the front slider bracket.

Go to the rear of the cabinet to tighten the slider rail screws. If there is not enough room to work at the back of the cabinet, the ZX Station may need to be removed to tighten the rail screws.

The ZX Station should now slide in and out smoothly. If not, repeat these steps.

The ZX Station should slide in and out easily. If not, repeat these adjustment steps.

SECURING ZX STATION IN CABINET FRAME

Use four ovalhead Phillips screws, stainless steel and nylon recep- tacle washers to secure the front panel of the ZX Station to the front of the cabinet frame.

11

Document# 27-0007UM Issued 11/00 Rev. 1.0

Image 11
Contents ZX Station FCC Information RegulatoryContents Starting Point Shipment ContentsFIELD-READY Product DescriptionStarting Point Tools Required PrecautionsSlide Removal Install SlidesInstall the Slides in Cabinet Frame Installation Test Install ZX StationInstall the ZX Station in Cabinet Frame Securing ZX Station in Cabinet Frame Final AdjustmentsInstalling Cables CD-ROM Powering UPOperation Controls and DisplaysTranzpak Front Panel Disk Module Handle Function SwitchFront Panel Functioning Installing Disk Module Powering UP the Hard Disk Setting the Scsi ID Locking the Disk Module and Hard Disk Function Switch Electrical DescriptionFunction Switch Versions Operation Removing the Disk Module Powering Down the Hard DiskOperating the Disk Module Carrying the Disk Module Installing Your OWN Hard Disk DriveClosing the ZX Station Internal AccessOpening the ZX Station Clean Front Panel MaintenanceFront Panel TroubleshootingEMI SpecificationsTBD Appendix WarrantyDept. at Z Microsystems 858 Handling Classified material Y2K Compliance Further Help SupportProviding Feedback Replacing PartsMicrosystems, Inc