Z Microsystems ZX Station manual Install Slides, Slide Removal

Page 8

Install Slides

SLIDE REMOVAL

Lay the ZX Station on a workbench.

The slide rail will reach a stop about half way out.

This is a safety stop to prevent the ZX Station from sliding out too far while mounted to the rack.

Simultaneously press in the safety catches on each slide rail and remove the slide rails all the way off the back of the ZX Station.

The slides should now be separated from the ZX Station.

8

Document# 27-0007UM Issued 11/00 Rev. 1.0

Image 8
Contents ZX Station Regulatory FCC InformationContents Shipment Contents Starting PointProduct Description FIELD-READYStarting Point Precautions Tools RequiredInstall Slides Slide RemovalInstall the Slides in Cabinet Frame Installation Test Install ZX StationInstall the ZX Station in Cabinet Frame Final Adjustments Securing ZX Station in Cabinet FrameInstalling Cables Powering UP OperationControls and Displays CD-ROMTranzpak Front Panel Function Switch Disk Module HandleFront Panel Functioning Installing Disk Module Powering UP the Hard Disk Setting the Scsi ID Locking the Disk Module and Hard Disk Function Switch Electrical DescriptionFunction Switch Versions Operation Removing the Disk Module Powering Down the Hard DiskOperating the Disk Module Installing Your OWN Hard Disk Drive Carrying the Disk ModuleClosing the ZX Station Internal AccessOpening the ZX Station Maintenance Clean Front PanelTroubleshooting Front PanelEMI SpecificationsTBD Warranty AppendixDept. at Z Microsystems 858 Handling Classified material Y2K Compliance Support Further HelpReplacing Parts Providing FeedbackMicrosystems, Inc