Z Microsystems ZX Station manual Tools Required, Precautions

Page 7

Starting Point

TOOLS REQUIRED

DANGER: To avoid shock hazard:

Do not connect or disconnect the ZX Station during an electrical storm.

The power cord plug must be connected to a properly wired and grounded power outlet.

Any equipment to which the ZX Station will be attached must also be connected to properly wired and grounded power outlets.

Required Tools and Equipment

Phillips screwdriver with about 10" shaft.

Adjustable wrench or box wrenches

PRECAUTIONS

NOTE: For the fastest and easiest installation of the ZX Station, follow these steps in the sequence they are presented.

In preparation to install the ZX Station, take the following precau- tionary steps:

Verify the ZX Station power switch is off. If the power is off, the light on the front panel will not be illuminated.

7

Document# 27-0007UM Issued 11/00 Rev. 1.0

Image 7
Contents ZX Station FCC Information RegulatoryContents Starting Point Shipment ContentsFIELD-READY Product DescriptionStarting Point Tools Required PrecautionsSlide Removal Install SlidesInstall the Slides in Cabinet Frame Install the ZX Station in Cabinet Frame Install ZX StationInstallation Test Securing ZX Station in Cabinet Frame Final AdjustmentsInstalling Cables CD-ROM Powering UPOperation Controls and DisplaysTranzpak Front Panel Disk Module Handle Function SwitchFront Panel Functioning Installing Disk Module Powering UP the Hard Disk Setting the Scsi ID Function Switch Versions Function Switch Electrical DescriptionLocking the Disk Module and Hard Disk Operation Operating the Disk Module Powering Down the Hard DiskRemoving the Disk Module Carrying the Disk Module Installing Your OWN Hard Disk DriveOpening the ZX Station Internal AccessClosing the ZX Station Clean Front Panel MaintenanceFront Panel TroubleshootingTBD SpecificationsEMI Appendix WarrantyDept. at Z Microsystems 858 Handling Classified material Y2K Compliance Further Help SupportProviding Feedback Replacing PartsMicrosystems, Inc