Proper use, Intended purpose | Kathrein MobiSet 2 CAP 210, CAP 310

Proper use

Intended purpose

The MobiSet 3 digital CAP 310 is designed to receive digital TV and radio programs via satellite. The turntable is intended for the Kathrein planar antenna BAS 60. This antenna can be used to receive digital TV and radio signals in the frequency range from 10.70 to 12.75 GHz; the antenna cannot receive terrestrial signals (e.g. DVB-T).

The turntable can only be used in conjunction with a Kathrein UFD 170 combi receiver or the Kathrein UFD 540 digital receiver and HDS 160 control unit. In conjunction with these two receivers, the turntable provides fully automatic alignment of the planar antenna to receive digital satellite signals. The turntable is designed for use in stationary caravans or motorhomes.

Any use other than that speciﬁed above will void the warranty or guarantee.

The following circumstances result in the loss of all warranty and liability claims towards the manufacturer:

	•	Improper installation
	•	Use of non-speciﬁed mounting materials, which cannot guarantee
		the mechanical reliability of the antenna system
	• Non-permissible use, e.g. use of the planar antenna for storage
	• Structural changes or interference with the components and mounting
		accessories in the set, which could endanger both the mechanical
		and functional reliability
	• Improper or forcible opening of the components
	• Use of cleaners containing solvents, such as acetone, nitro-cellulose
		combination thinner, naphtha etc.
	• Failure to observe installation and safety instructions in this manual
Note:	The maximum permissible speed for vehicles with a BAS 60/HDP 171
	receiver unit mounted on the roof is 130 km/h. Before commencing
	a journey, the planar antenna must always be lowered into horizontal
	position (park position).
	The turntable may be operated in an ambient temperature range of
	-10 °C to +40 °C. Operating the system outside these ranges can
	result in malfunctions or damage to the system.

Installation instructions

The turntable may only be assembled by qualiﬁed specialist personnel.

To prevent hazards during installation, operation or when driving on public highways, the instructions and information in this manual must be strictly adhered to. Proper installation and connection of the system are pre-requisites for conformity with the corresponding standards.

This has been documented in advance in the CE label and the declaration of conformity in the appendix to this manual.