Installation and connection
Set up electrical connections. Connect UFD 170/UFD 540 receiver.
Connect connecting/control unit to battery.
The antenna must always be lowered into horizontal position (park position) while driving!
Maximum driving speed of the vehicle: 130 km/h
Installation of UFD 170
| The turntable is actuated exclusively by the UFD 170 combi satellite |
| receiver. |
| The cable lengths must be taken into account when choosing the |
| installation location. |
| The UFD 170 is equipped with a power saving circuit and a separate |
| infrared transmitter, which means that the unit does not need to be |
| placed where it is visible. You can therefore fit the UFD 170 out of sight |
| in any location, e.g. on cupboard walls, side walls or the base of storage |
| compartments. |
Note: | When choosing the installation location, bear in mind that the on/off |
| switch, the fuse for subsequent monitoring and the slots for inserting |
| common interface modules should always be accessible. |
| In addition, the following points should be taken into account: |
| • The wall thickness at the installation location must be at least 12 mm, |
| as otherwise the screws will emerge on the other side or damage |
| the surface |
| • The receiver must be placed in such a way as to allow sufficient |
| air circulation behind, above and next to the unit. Installation on |
| |
| • Ensure that the cupboard or storage compartment in which the unit |
| is housed is adequately ventilated, to prevent a build up of heat |
| • No cables etc. placed behind or in the wall should be damaged when |
| tightening the screws |
| • The receiver is designed exclusively for installation in dry, interior |
| locations. The installation location must be protected against |
| moisture |
| • The connecting cables must be strain relieved |
20