Magma P13RR-TEL user manual RechecktheInstallation, Applying PowerCorrectly, Starting Up

M A G M A

RechecktheInstallation

Check your installation before powering up the MAGMA expansion chassis for the first time. Although the power supply has an over voltage protection device built into it, it may not "trip" in time to fully protect a device that has been improperly connected, or whose power cable has been damaged.

Applying PowerCorrectly

Starting Up:

You must apply power to the MAGMA expansion chassis BEFORE you power up your computer. This will allow the higher numbered PCI buses in the PCI bus hierarchy to be at a stable state when the host system issues its master power-on bus reset. In systems that perform automatic PCI bus configuration, this will allow the configuration code to recognize the PCI bus hierarchy and any attached

devices.

There is an On/Off switch on the front panel, as well as LED indicators to indicate power status. Verify that the green power indicators are ON.

Windows XP and Windows 2000 Start Up

As your Windows XP/2000 computer starts up, you will see a small message box pop- up in the lower-right corner of the screen to alert you that Windows has found new hardware.

You are now ready to go. No drivers are needed. Now go to Chapter 3 Verify Installation.

6Chapter 2 Hardware Installation