Kathrein MSK 25 manual DVB-C/DVB-T Change-Over

Page 33

TV measurement

DVB-C/DVB-T Change-Over

Press [2ndF] [STD].

1=ANALOG 3=DVBT

2=DVBC 0=Std.

1=QAM64 2=QAM128 3=DOC64

1=6.900 2=6.952

3=6.875 4=USER

LC display:

•1 = Analogue reception

•2 = DVB-C reception

•3 = DVB-T reception (if this option is provided)

•0 = Standard menu

Press [2] to change over to DVB-C standard

LC display:

•1 = QAM 64 demodulation

•2 = QAM 128 demodulation

•3 = DOCSIS QAM 64 demodulation

Press [1] to set the QAM 64 symbol rate

LC display:

•1 = 6.900 MS

•2 = 6.952 MS

•3 = 6.875 MS

•4 = USER MS

Select the corresponding symbol rate by pressing the corresponding key

[1] [4].

The standard setting will then automatically be closed.

Image 33

Contents MSK 25 Satellite/TV/FM Test Receiver analogue/digital Preface Contents Mpeg Picture Representation option in DVB-C or DVB-T option Safety Rules Signs and SymbolsGeneral Information Additionally included in DeliveryPage Qpsk Overview of FunctionsQAM CofdmLNB 0/5 20 SAT Technical DataDVB-S-MER1 Control Elements Control Elements and IndicatorsConnections right hand side TFT Colour ScreenSAT/DVB-S TV/DVB-C/*DVB-T Short Cut OverviewRF Input Socket ConnectionsExternal DC Voltage Supply Scart OutputSwitching-Off Switching-UpCommissioning Software Accu −−−−− LEV 48.5dBuVFactory Setting on Delivery Setup-MenuSetup Menu Setting Setup Menu Call-UpMains Operation and Battery Operation Battery OperationMains Operation Standard Change-Over SAT measurement2ndF STD Press 2ndF STDSAT Menu Frequency Entry Frequency Display and Frequency EntryExample FR1508.0MHz LEV 86.5dBuVSAT Analogue Level Measurement SAT DVB-S Level MeasurementLevel Overflow and Level Underflow Locating Satellites Calling up Scan mode Press 2ndF ScanScan Menu LEV-Range2 SAT Example 2ndF 2ndF ExitBearing for Individual Reception Frequencies Bearing Menu LEV-Range2 SAT ExamplePress 2ndF Level SAT Analogue Sound Carrier Frequency Press 2ndF SCBwnarrow Mpeg Picture Representation option in DVB-S DVB-S MER, BER and Offset MeasurementCalling up DVB-S measurement MER12.6dB MHz BER1.7e-7Press 2ndF LNB LNB Voltage and 22 kHz/60 Hz Change-OverPress 2nF LNB Example LNB14,0V 22kHz 150mAOr + DiSEqC Digital Satellite Equipment ControlFraming Byte Menu Press 2ndF SAT-CTRLHEX Hex Byte Description Address Byte MenuCommand Byte Menu SAT measurement Data Byte Menu Simple Tone Burst DiSEqC2ndF SAT-CTRL 2ndF 2ndFTV measurement Bis=ANALOG 3=DVBT DVB-C/DVB-T Change-Over Channel display and channel entry TV Channel Setting Menu Example CHS.11 LEV 62,5dBuVChanging over to special channel Press ./S 1Then press 1 7 5 ./S 2 5 Enter TV Frequency Entry Mode Example CH175,25 LEV 65,0dBuVTV/DVB-C/DVB-T Level Measurement Level Measurement TV AnalogueLEV.dBuV LEV.dBuVLEV-RANGE2 TV Bearing MenuSound Carrier Distance and Sound Carrier Level TT1 TT22ndF SC Example SC 5.85 MHz BER=2.145E-05 Nicam Sound Bit Error Rate MeasurementMpeg Picture Representation option in DVB-C or DVB-T option DVB-C/DVB-T option, MER, BER and Offset MeasurementMER30.5dB MHz BER2.0e-8 Calling up DVB-C/DVB-T option measurementFrequency Indication and Frequency Entry FM measurementFM Frequency Entry Menu Example LEV 65.0dBuV Then press 9 9 ./S 2 5 EnterLevel Measurement Fr104.80MHz LEV 86.5dBuVFR104.80MHz LEV .dBuV FR104,80MHz LEV¯¯¯.¯dBuV LEV-RANGE2 FM SAT Spectrum Spectrum MeasurementTV Spectrum SAT-FullTV Spectrum Menu TV-Full FM SpectrumVHF UHF TV-NarrowMaintenance Changing the BatteryCustomer Service Signal-to-Noise-Ratio Technical Appendix+14.1 dB Instruction Set for 9xx Kathrein Matrix Production Run DiSEqC Commands for Kathrein MatricesInstruction Set for EXR 20 Kathrein Matrix Instruction Set for EXR 22 Kathrein MatrixVRF-CCIR URF-CCIR Channel TablesVHF UHF III Technical Appendix Technical Appendix Technical Appendix Technical Appendix 936.2642/D/1005/ZWT Subject to technical modifications